Development of miniaturized trigatron switch and experimental investigation of its switching performance

Abstract

There is an increasing interest in synchronization of multiple spark gap switches while maintaining compact geometry, less-complex circuit, and low jitter switching performances. A study of the effect of electrical parameters on switching performances is necessary for the operation of a large number of simultaneous switches. A miniaturized trigatron switch assembly (Outer diameter: 35 mm and thickness: 5 mm) is developed and experimentally investigated for switching performance. A polyether ether ketone insulator and brass conductor electrodes are utilized due to their high insulation and solderable properties, respectively. Important switching parameters, delay time, switch time delay, jitter in delay time, discharging peak current, trigger break down time, and trigger break down voltage, are studied under four typical conditions. These four conditions are: (a) a fast trigger (FT) with normal circuit inductance (10 ns, 20 nH); (b) a fast trigger with higher circuit inductance (10 ns and 500 nH); (c) a slow trigger (ST) with normal circuit inductance (250 ns and 20 nH) and (d) a slow trigger with higher circuit inductance (250 ns and 500 nH). Subsequently, three trigatron spark gaps (4 kV, 5 kA, >100 shots, 4 nH, and 20 mΩ) are simultaneously switched within 5 ns time. Many experimental results are the first of their kind in terms of compact switch development, switching performance, and single electrical trigger based synchronization. This paper will also add a good value to presently available knowledge through systematically implementing the simultaneous switching condition for the generation of 5 kA, 50 ns current pulses. These low cost (US$40) trigatron switches can be utilized in low energy, compact pulsed power applications.