Development of in‐pipe microrobot using microwave energy transmission

Abstract

SUMMARYMost robots moving autonomously are equipped with batteries as an energy source. Since the energy stored in the batteries is proportional to their volume, the operating time is drastically reduced as the robot is miniaturized. To resolve this problem, it is necessary to supply energy externally. Considering the checking of pipes in electric power generating stations as the target, a microrobot has been developed that autonomously moves inside the pipe with energy supplied by microwaves. A previous report [1] noted the problems that the energy could not be supplied when the robot is rotated and that the power supply method was not suitable for the sensor circuit, since the driving waveform of the actuator was produced by amplitude modulation of the microwaves. In the present paper, a method is proposed to allow the supplying of energy with circular polarization by means of four rectennas. Autonomous reversing motion is successfully achieved by installing a driver control circuit and an infrared sensor on the robot. The microrobot proposed in this paper moves at 10 mm/s, using a power of 200 mW supplied in a pipe with a diameter of 15 mm.

Wireless Power-Data Transmission for Industrial Internet of Things: Simulations and Experiments

“…The receiving unit can be placed anywhere along the profile of the pipeline network and the signal/power can be received. The pipelines are known to cause maximum loss and shielding of the RF signals [28], [29]. This article has been accepted for publication in a future issue of this journal, but has not been fully edited.…”

The Research of Passive Wake-Up Technology Based on the Microwave Power Transmission

“…In recent years, Jenn and other people developed remote-control aircraft ''MRPV'' which could be recharged by MPT [11]. DENSO, company of Japan, developed micro pipe robot based on MPT [12]. These achievements demonstrate that MPT can also make sense in low-power fields.…”

Robotic devices for water main in‐pipe inspection: A survey

“…However, there is some research on untethered in-pipe robots. The energy issue is commonly solved by the use of batteries, although other systems, such as gathering the required energy from the fluid itself (Li Duan-neng, Yang Yi-min, & Luo Chuan-lin, 2005) or by microwave transmission (Shibata, Sasaya, & Kawahara, 2001), have been investigated.…”