Development of coupled fluid-flow/geomechanics model considering storage and transport mechanism in shale gas reservoirs with complex fracture morphology

Abstract

Field observations frequently demonstrate stress fluctuations resulting from the reservoir depletion. The development of reservoirs, particularly the completion of infill wells and refracturing, can be significantly impacted by stress changes in and around drainage areas. Previous studies mainly focus on plane fractures and few studies consider the influence of complex transport and storage mechanism and irregular fracture geometry on stress evolution in shale gas reservoirs. Based on the embedded discrete fracture model (EDFM) and finite-volume method (FVM), a coupled geomechanics/ fluid model has been successfully developed considering the adsorption, desorption, diffusion and slippage of shale gas. This model achieves coupling simulation of natural fractures, hydraulic fractures with complex geometry, storage and transport mechanism, reservoir stress, and pore-elastic effect. The open-source software OpenFOAM is used as the main solver for this model. The stress calculation and productivity simulation of the model are verified by the classical poroelasticity problem and the simulation results of published research and commercial simulator with EDFM respectively. The simulation results indicate that σ xx , σ yy , σ xy and Δσ changes with time and space due to the time effect and anisotropy of formation pressure depletion; Due to the influence of different mechanisms on shale gas storage and transport, the reservoir pressure and stress distribution under different mechanisms are different; Among them, the stress with full mechanisms differs the most compared to the stress without any mechanism. The reservoir with stronger stress sensitivity (smaller Biot coefficient) is less sensitive to formation pressure depletion, and the stress variation range is smaller. For reservoirs with weak stress sensitivity, formation pressure depletion is more likely to lead to stress reversal. Under the influence of fracture geometry, the pressure depletion regions caused by the three types of fracture geometry are approximately rectangular, parallelogram and square, respectively. The corresponding σ xx , σ yy and Δσ also have great differences in spatial distribution and values. Therefore, the time effect, shale gas storage and transport mechanism and the influence of complex fracture geometry should be considered when predicting pressure depletion induced stress under the condition of simultaneous production. This study is of great significance for understanding the evolution law of stress induced by pressure consumption, as well as the design of infill wells and repeated fracturing.