Development of an arduino-based integrated system for sensing of hydrogen peroxide

Gao, Weibao; Luo, Xian; Liu, Yiqun; Zhao, Yuping; Cui, Yue

doi:10.1016/j.snr.2021.100045

Cited by 9 publications

(4 citation statements)

References 40 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…A processing unit, built around the micro-controller of the Arduino Mega board; is programmed to ensure the automation of the pumping station [18]. This unit captures the information delivered by the various sensors and controls the actuators accordingly to a computer via a RS232/USB serial converter cable facilitate the communication and programming with Arduino software or MATLAB, the main characteristic are illustrated in Table 3 [19], [20]. Current transducer LA55-P is electronic component for measuring several types of currents (DC, AC, pulsed,...) with galvanic separation between the primary circuit up to 50 A and the secondary circuit [21], the relationship between primary circuit current and the secondary circuit current is (3), with I s : secondary circuit current, N : spears number, I p : primary nominal current, R m : measuring resistance, V m : measuring voltage [22].…”

Section: Arduino Megamentioning

confidence: 99%

Implementation of fuzzy logic MPPT based on Arduino in small scale PV pumping system

Mohamed,

Aicha

2024

IJPEDS

View full text Add to dashboard Cite

The performance of photovoltaic (PV) affected directly by climatic changes, The controller maintain maximum potential energy conversation to operate the pimping system at nominal conditions, fuzzy logic intelligent controllers are successfully suitable and applicable in engineering and applied science. The aim of this paper is present an experimental approach in Implementation of fuzzy logic maximum power point tracking (MPPT) with boost converter based on Arduino Mega micro-controller to maximize energy production in different weather condition applied to small scale pumping system for water and chemical fluid analyses in isolated area. The system is supplied by 20 (W) solar photovoltaic (PV) panel. This paper present a real-time MATLAB/Simulink fuzzy logic method controlling and monitoring MPPT application using an low cost Arduino Mega micro-controller combined with (LV25, LP55) sensors controlling boost converter interconnected with solar panel and plastic pump.

show abstract

Section: Arduino Megamentioning

confidence: 99%

Implementation of fuzzy logic MPPT based on Arduino in small scale PV pumping system

Mohamed,

Aicha

2024

IJPEDS

View full text Add to dashboard Cite

show abstract

“…Both lines are open-drain or open-collector structures and require external pull-up resistors to mount multiple devices. Each device has its own address, and the host selects different devices through different addresses [6]. As shown in Figure 1.…”

Section: Basic Characteristicsmentioning

confidence: 99%

Related methods introduction and application analysis of I2C bus

Wang,

Weng,

2023

ACE

View full text Add to dashboard Cite

Major changes have taken place in the global integrated circuit industry, and various emerging technologies have promoted the development of chips in the direction of smaller size and larger scale. Verification is the key line of defense to ensure the correct realization of chip functions. Verification also takes up a lot of time in the actual chip project cycle. Improving verification efficiency is of great significance to reducing chip costs. Universal Serial Bus IIC (Inter-Integrated Circuit) has the simple structure of two-way and double-wire, unique data transmission mode and its wide use in system-on-chip. This paper presents a design and implementation of IIC protocol based on Verilog language using Modelsim simulation software. The IIC protocol is a serial communication protocol used for data transfer between electronic devices. The paper provides a detailed introduction to the principles, communication process, and data format of the IIC protocol, and proposes a Verilog-based design solution. Through Modelsim simulation, the correctness and reliability of the design are verified

show abstract

“…As a well-recognized microcontroller board, the Arduino microcontroller (AM) offers the predominance features such as open-source software and hardware with a large open library, affordable, user-convenience, and easy-to-develop [34]. Currently, AM has been employed for various sensor development.…”

mentioning

confidence: 99%

“…Currently, AM has been employed for various sensor development. Gao et al [34] developed hydrogen peroxide using an Arduino-based system. González-Buesa and Salvador [35] measure the continuous measurement of CO 2 concentration using AM, while Zouheir et al [36] employed AM for developing low-cost and real-time humidity sensing.…”

mentioning

confidence: 99%

A New Platform of Iron Oxide-Based Nanoparticles Assay Using GMR Chip-Based Sensor With Microcontroller

2022

View full text Add to dashboard Cite

The low-cost, simple, and fast quantitative assay of magnetic nanoparticles (MNPs) is important for the development of magnetic-based immunoassay applications. However, the bulky sensing element and instruments of the recent iron oxide-based MNPs assays are still concerns that should be resolved. This article reports the new platform of an iron oxide-based MNPs label assay using the commercial giant magnetoresistance (GMR) chip AAL024, manufactured by Nonvolatile Electronics (NVE) Corporation, complemented with a basic differential amplifier circuit and Arduino microcontroller (AM) to acquire the digital output voltage. The as-prepared Fe 3 O 4 @Ag label possessed (15 ± 2.6) nm of average size and behaved as soft ferromagnetic with 52.1 emu/g of saturation magnetization, and 0.15 kOe of coercive field. Sensor performance for magnetic field detection, as well as Fe 3 O 4 @Ag nanoparticles label assay, was evaluated. The results show the implementation of a basic differential amplifier op-amp circuit succeed to magnify the sensor's response to the magnetic field up to 23 times with the output voltage in the order of volt. The employment of the AM as a voltage supply of the GMR chip, an analog-to-digital converter, and a voltage gauge simplifies the data acquisition without the additional measuring instrument. Meanwhile, for the purpose of the Fe 3 O 4 @Ag nanoparticles label assay, the sensor revealed promising performance due to the high signal linearity and the rapid detection which is only 30 s with acceptable signal stabilities.

show abstract

Development of an arduino-based integrated system for sensing of hydrogen peroxide

Cited by 9 publications

References 40 publications

Implementation of fuzzy logic MPPT based on Arduino in small scale PV pumping system

Implementation of fuzzy logic MPPT based on Arduino in small scale PV pumping system

Related methods introduction and application analysis of I2C bus

A New Platform of Iron Oxide-Based Nanoparticles Assay Using GMR Chip-Based Sensor With Microcontroller

Contact Info

Product

Resources

About