Development of AA6082 based metal matrix composite using Sic,Ti,Ni,Cr by conventional casting technique

Mohanraj, C.; Kumar, K. Murali; Praveenkumar, K.; Mukesh, S.

doi:10.1016/j.matpr.2020.04.655

Cited by 2 publications

(1 citation statement)

References 9 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The results showed that Al-SiC-Gr is an exceptional combination of composites with a high strength-to-weight ratio. Mohanraj et al [ 13 ] have produced composites based on AA6082 using SiC, Ti, Ni, and Cr. The results showed that the hardness and tensile strength increased in comparison with the base metal.…”

Section: Introductionmentioning

confidence: 99%

On Investigating the Microstructural, Mechanical, and Tribological Properties of Hybrid FeGr1/SiC/Gr Metal Matrix Composites

2021

View full text Add to dashboard Cite

In recent years, studies of different properties of hybrid metal matrix composites, as well as very detailed issues, have been published. In this article, ready-made iron, graphite, and silicon carbide powders were used to produce the base material and composites. An analysis of some microstructural and mechanical properties, as well as the tribological behavior of metal matrix composites (MMCs), based on FeGr1 sintered material with the single and hybrid addition of a silicon carbide and graphite was undertaken. During the study, the flexural and compressive strength of MMCs were analyzed and changes of the momentary coefficient of friction, the temperature of friction, as well as wear rates of the MMCs tested were monitored. Based on the results, it was revealed that wear rates decreased 12-fold in comparison to the base material when SiC or SiC + Gr were added. Further research into MMCs with ceramic particle additives is proposed.

show abstract

Section: Introductionmentioning

confidence: 99%