Development and Testing of a Wireline-Deployed Positive-Displacement Pump for Late-Life Wells

Abstract

Summary What do you do after plunger lifting? What if lift gas is not readily available or your liquid level is around a bend? What can you do with a well that has low reservoir pressure, liquid-loading trouble, and fragile economics? Do you give up on the remaining reserves and advance to plugging and abandonment? These questions were considered, and the answers were found to be unsatisfactory. This paper will describe the development and testing of a novel wireline-deployed positive-displacement pump (WLPDP) that was invented to address these challenges. Artificial-lift (AL) pumps have historically been developed with high-producing oil wells in mind. Pumps for late-life wells have mostly been repurposed from these applications and optimized for reduced liquids production. The WLPDP development began with the constraints of late-life wells with the goal of addressing reserves that conventional AL methods would struggle to produce profitably. Internal and industry-wide data were first reviewed to determine what WLPDP specifications would address the majority of late-life wells. The primary target was gas wells, although “stripper” oil wells were also considered. The resulting goal was a pump that could deliver 30 BFPD from 10,000-ft true vertical depth (TVD). The pumping system must be cost-effective to be a viable solution, which led to several design boundaries. Pumps fail and replacement costs can drive economics, so the system must be deployable/retrievable through tubing. The majority of new onshore wells have tortuous geometries, so the system must be able to function at the desired depth despite them—without damaging associated downhole components. The system should use as many off-the-shelf components and known technologies as possible to reduce development costs and encourage integration. Finally, the pump should be able to handle a variety of wellbore liquids, produced gases, and limited solids. The WLPDP was designed to meet the established specifications and boundary conditions. The 2.25-in.-outer-diameter (OD) pump is deployed through tubing. and powered with a standard wireline (WL) logging cable. The cable powers a direct-current (DC) motor that drives an axial piston pump. The piston pump circulates a dielectric oil between two bladders by means of a switching valve. When each bladder expands, it pressurizes inlet-wellbore liquids, pushing them out of the well. Produced gas flows in the annulus between the tubing and production casing. The intake/discharge check valves and bladders are the only internal pump components that contact the wellbore fluids. The WLPDP system was able to meet the design-volume/pressure specifications in all orientations, as confirmed through laboratory and integration testing. Targeted studies were conducted to verify/improve check-valve reliability, gas handling, elastomer suitability, and cable-corrosion resistance. The results of these and related studies will be discussed in the paper.

A comprehensive review of sucker rod pumps’ components, diagnostics, mathematical models, and common failures and mitigations

“…If the pump fails, production will cease since fluid transmission will be ceased temporarily until the pump is fixed, or permanently if the pump completely fails; in this case, pump replacement will be needed. Downhole sensors and electrical gauges might fail due to electrical failure (Langbauer et al 2020) Wireline deployed positive displacement pump Developed and tested a sucker rod pump that can be deployed using wireline for faster and higher applicability ranges (Romer et al 2021) Open Access This article is licensed under a Creative Commons Attribution 4.0 International License, which permits use, sharing, adaptation, distribution and reproduction in any medium or format, as long as you give appropriate credit to the original author(s) and the source, provide a link to the Creative Commons licence, and indicate if changes were made. The images or other third party material in this article are included in the article's Creative Commons licence, unless indicated otherwise in a credit line to the material.…”