“…The non-ionic surfactants do not contribute any charge to the nanoemulsion particle and this indicates that negative charge particles do not affect the stability of formed nanoemulsion [ 61 ]. Our results also agreed with Kulkarni et al who prepared solid self-nanoemulsifying formulation of Rosuvastatin Calcium and found that the zeta potential values were negative in between −4.93 and −11.8 mV [ 62 ].…”
The main purpose of this study was to develop a solid self-nanoemulsifying drug delivery system (S-SNEDDS) of Olmesartan (OLM) for enhancement of its solubility and dissolution rate. In this study, liquid SNEDDS containing Olmesartan was formulated and further developed into a solid form by the spray drying technique using Aerosil 200 as a solid carrier. Based on the preliminary screening of different unloaded SNEDDS formulae, eight formulae of OLM loaded SNEEDS were prepared using Capryol 90, Cremophor RH40 and Transcutol HP as oil, surfactant and cosurfactant, respectively. Results showed that the mean droplet size of all reconstituted SNEDDS was found to be in the nanometric range (14.91–22.97 nm) with optimum PDI values (0.036–0.241). All formulae also showed rapid emulsification time (15.46 ± 1.34–24.17 ± 1.47 s), good optical clarity (98.33% ± 0.16%–99.87% ± 0.31%) and high drug loading efficiency (96.41% ± 1.20%–99.65% ± 1.11%). TEM analysis revealed the formation of spherical and homogeneous droplets with a size smaller than 50 nm. In vitro release of OLM from SNEDDS formulae showed that more than 90% of OLM released in approximately 90 min. Optimized SNEDDS formulae were selected to be developed into S-SNEDDS using the spray drying technique. The prepared S-SNEDDS formulae were evaluated for flow properties, differential scanning calorimetry (DSC), scanning electron microscopy (SEM), reconstitution properties, drug content and in vitro dissolution study. It was found that S-SNEDDS formulae showed good flow properties and high drug content. Reconstitution properties of S-SNEDDS showed spontaneous self-nanoemulsification and no sign of phase separation. DSC thermograms revealed that OLM was in solubilized form and FTIR supported these findings. SEM photographs showed smooth uniform surface of S-SNEDDS with less aggregation. Results of the in vitro drug release showed that there was great enhancement in the dissolution rate of OLM. To clarify the possible improvement in pharmacokinetic behavior of OLM S-SNEDDS, plasma concentration-time curve profiles of OLM after the oral administration of optimized S-SNEDDS formula (F3) were compared to marketed product and pure drug in suspension. At all time points, it was observed that OLM plasma concentrations in rats treated with S-SNEDDS were significantly higher than those treated with the drug in suspension and marketed product.
“…The non-ionic surfactants do not contribute any charge to the nanoemulsion particle and this indicates that negative charge particles do not affect the stability of formed nanoemulsion [ 61 ]. Our results also agreed with Kulkarni et al who prepared solid self-nanoemulsifying formulation of Rosuvastatin Calcium and found that the zeta potential values were negative in between −4.93 and −11.8 mV [ 62 ].…”
The main purpose of this study was to develop a solid self-nanoemulsifying drug delivery system (S-SNEDDS) of Olmesartan (OLM) for enhancement of its solubility and dissolution rate. In this study, liquid SNEDDS containing Olmesartan was formulated and further developed into a solid form by the spray drying technique using Aerosil 200 as a solid carrier. Based on the preliminary screening of different unloaded SNEDDS formulae, eight formulae of OLM loaded SNEEDS were prepared using Capryol 90, Cremophor RH40 and Transcutol HP as oil, surfactant and cosurfactant, respectively. Results showed that the mean droplet size of all reconstituted SNEDDS was found to be in the nanometric range (14.91–22.97 nm) with optimum PDI values (0.036–0.241). All formulae also showed rapid emulsification time (15.46 ± 1.34–24.17 ± 1.47 s), good optical clarity (98.33% ± 0.16%–99.87% ± 0.31%) and high drug loading efficiency (96.41% ± 1.20%–99.65% ± 1.11%). TEM analysis revealed the formation of spherical and homogeneous droplets with a size smaller than 50 nm. In vitro release of OLM from SNEDDS formulae showed that more than 90% of OLM released in approximately 90 min. Optimized SNEDDS formulae were selected to be developed into S-SNEDDS using the spray drying technique. The prepared S-SNEDDS formulae were evaluated for flow properties, differential scanning calorimetry (DSC), scanning electron microscopy (SEM), reconstitution properties, drug content and in vitro dissolution study. It was found that S-SNEDDS formulae showed good flow properties and high drug content. Reconstitution properties of S-SNEDDS showed spontaneous self-nanoemulsification and no sign of phase separation. DSC thermograms revealed that OLM was in solubilized form and FTIR supported these findings. SEM photographs showed smooth uniform surface of S-SNEDDS with less aggregation. Results of the in vitro drug release showed that there was great enhancement in the dissolution rate of OLM. To clarify the possible improvement in pharmacokinetic behavior of OLM S-SNEDDS, plasma concentration-time curve profiles of OLM after the oral administration of optimized S-SNEDDS formula (F3) were compared to marketed product and pure drug in suspension. At all time points, it was observed that OLM plasma concentrations in rats treated with S-SNEDDS were significantly higher than those treated with the drug in suspension and marketed product.
“…It may be used to reduce the progression of atherosclerosis and for the primary prevention of cardiovascular disease (Sweetman, 2009, Nissen et al, 2006, Lennernas and Fager, 1997). Due to its low solubility in water, reported as 0.33 mg/ml (Alshora et al, 2016, Kulkarni et al, 2015), rosuvastatin exhibits poor solubility in gastrointestinal fluids and, with extensive first-pass metabolism, its oral bioavailability is limited to about 20% (Rohini et al, 2014, Scott et al, 2004). Fig.…”
The objective was to use caffeine and Soluplus® to improve the dissolution rate and to maintain a concentration of BCS Class II rosuvastatin calcium that exceeds its solubility. Caffeine and Soluplus® together substantially improved the dissolution rate and the extent of rosuvastatin release. Formulations for direct compression tablets included Formulation F1, a control with drug but with neither caffeine nor Soluplus® present; F2 with drug-caffeine complex; F3 with drug and Soluplus® and F4 with drug-caffeine complex and Soluplus®. Each formulation blend provided satisfactory flow properties. Tablets were comparable in mass, hardness and friability. A marked decrease in disintegration time occurred when the hydrotropic or micellar agent was included in the formulation. Assay (98–100%) and content uniformity (99–100%) results met requirements. Release studies in pH 1.2, 6.6, and 6.8 buffers revealed the superiority of F4. At 45 min sampling time, F3 and F4 tablets each provided a cumulative drug release greater than 70% in each medium. F2 tablets exhibited compliance to official standards in pH 6.6 and 6.8 buffers but not in pH 1.2 buffer, whereas tablets based on F1 failed in each medium. Two-factor ANOVA of the release data revealed a statistical difference across the four formulations in each release medium. Pairwise comparison of release profiles demonstrated that, of the four formulations, F4 provided the most effectively enhanced dissolution rate, improvement to the extent of drug release and support of a concentration higher than the solubility of rosuvastatin calcium.
“…The results were in perfect agreement with the previous researchers who prepared stable colloidal system with a low negative zeta potential system. 27,28 The absolute values of zeta potential were lower than the literature which may be attributed to the presence of non-ionic surfactant which sterically stabilizes the system by forming a coat around their surface. For personal use only.…”
Objective: The purpose of this study was to prepare proniosomal vesicles of Telmisartan (TEL) to be compressed into tablets which will be further evaluated in vitro and in vivo. Materials and Methods: An experimental design was adopted using surfactants of different HLB values (span 40-brij 35), different cholesterol ratios (20-50%) and different phospholipid types (egg yolk-soyabean). Different responses were measured followed by tablet manufacturing. The highest EE was shown in F3 (85%) while the lowest value was obtained in F7 (8.4%). Finally, zeta potential results were in the range of −0.67 to −27.6 mv. Compressibility percent revealed that F5 showed an excellent flowability characteristic with a value of 9.74±1.61 while F3 and F6 showed good flowability characteristics. By the end of the release, F6 showed approximately 90% drug release. Results: F6 was selected for the in vivo study; C max was increased by 1.5-fold while AUC 0-∞ also increased significantly by 3-fold when compared with commercial tablet and finally, t max was increased by 3-fold indicating sustained release pattern. The relative bioavailability was also increased by 3.2-fold. Conclusion: The results of this study suggested that the formulation of compressed tablets containing more stable proniosomal powder extended the release of TEL and increased its bioavailability as well.
scite is a Brooklyn-based organization that helps researchers better discover and understand research articles through Smart Citations–citations that display the context of the citation and describe whether the article provides supporting or contrasting evidence. scite is used by students and researchers from around the world and is funded in part by the National Science Foundation and the National Institute on Drug Abuse of the National Institutes of Health.
