Determination of the Effective Diffusion Coefficient of Vacancies in Ultradispersed Electrolytic Iron and its Effect on Heat Treatment Conditions

Venediktov, Anatolii; Ovsyannikov, V. E.; Arhangelskiy, Leonid

doi:10.17212/1994-6309-2019-21.3-106-114

Cited by 1 publication

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Solid State Phenomena Vol. 303 COMSOL Multiphysics physical interfaces required to solve the problem [24]: -heat transfer in solids; -mass transfer in solids. The problem is solved in a two-dimensional setting.…”

Section: Model Of Austenite's Diffusion Saturationmentioning

confidence: 99%

Simulation of the Carbon Diffusion Saturation Gear from 15Cr2 Steel in the Cementation Process

Venediktov

Nekrasov

Kuz'min

et al. 2020

SSP

View full text Add to dashboard Cite

The studies on cementation focus exclusively on the carbon’s movement. It is described by diffusion equations, often with constant coefficients and without regard to the liaising with temperature. It does not allow to have regard to the further carbon diffusion into the workpiece with the lower temperature range. The most accurate prediction of carbon concentration profiles depending on the parameters of the carburization regime and the chemical composition of steel is possible with the mathematical models using. However, most models show good results for Fe-C austenite without affecting the effect of alloying substitution elements. Taking into account the influence of alloying elements leads to complex empirical dependencies with difficult selected coefficients. It makes their use difficult. The study describes the simulation using the finite element method for the process of austenite’s diffusion saturation Fe-C-Cr system with carbon during cementation. Here is an example of a steel gear 15Cr2 with the temperature influence. The COMSOL Multiphysics program is used to solve the problem numerically. It is found that the model of carbon diffusion in unalloyed austenite for the single-stage cementation regime is in good contact with the experimental data for the Fe-C-Cr austenite of 15Cr2 steel. For a two-stage process, the calculation of the carbon concentration in the surface layer has a slightly greater deviation from the experimental data than it is at a greater depth.

show abstract

Section: Model Of Austenite's Diffusion Saturationmentioning

confidence: 99%