Determination of optimal location of TCSC and STATCOM for congestion management in deregulated power system

Siddiqui, Anwar Shahzad; Khan, Mohd Tauseef; Iqbal, Fahad

doi:10.1007/s13198-014-0332-4

Cited by 22 publications

(9 citation statements)

References 7 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In [118], the selection of optimal location for FACTS devices were done to alleviate congestion with power losses reduction, voltage regulation and lower cost of operation. A function of the ratio of total active power loss without and with FACTS devices, the minimum and maximum voltage deviation and cost of FACTS devices were proposed as the weighted mean method to determine the optimal location in IEEE 14 bus system.…”

Section: A Power Lossmentioning

confidence: 99%

A Comprehensive Review on Optimal Location and Sizing of Reactive Power Compensation Using Hybrid-Based Approaches for Power Loss Reduction, Voltage Stability Improvement, Voltage Profile Enhancement and Loadability Enhancement

et al. 2020

View full text Add to dashboard Cite

Section: A Power Lossmentioning

confidence: 99%

A Comprehensive Review on Optimal Location and Sizing of Reactive Power Compensation Using Hybrid-Based Approaches for Power Loss Reduction, Voltage Stability Improvement, Voltage Profile Enhancement and Loadability Enhancement

et al. 2020

View full text Add to dashboard Cite

“…STATCOM is able to provide greater reactive current generation at depressed system voltages. It can provide voltage support and enhance the damping of inter-area oscillations [39]. It successfully improves the system steady state and dynamic exhibitions, controls power factor, minimize losses and permits power flow in existing lines, thus results in the post fault recovery of a transmission network.…”

Section: Statcommentioning

confidence: 99%

Modeling, Control and Placement of FACTS Devices: A Review

Haroon

Javed

Baig

et al. 2020

Mehran Univ. res. j. eng. technol.

View full text Add to dashboard Cite

Over the past two decades, developing distributed energy sources in electric power grid have created new challenges related to the power quality, voltage adjustment and proficient energy utilization. Power electronic converters are widely used to interface the emerging energy systems (without and with energy storage) and smart buildings with the transmission and distribution systems. Flexible Ac Transmission Systems (FACTS) and Voltage-Source Converters (VSC), with smart dynamic controllers, are emerging as stabilization and power filtering equipment to improve the power quality. FACTS devices are of vital significance for tackling the problem of voltage instability which is inevitable and leads to losses in transmission system networks. These devices provide fast voltage regulation, ensure system stability and reactive power compensation. In this regard, modeling, control and appropriate placement of these devices in the transmission lines have been of great importance for researchers of power transmission systems. By using high speed power electronic converters, FACTS perform many times faster than the conventional compensation techniques. FACTS not only provide fast voltage regulation but also damping of active power oscillations and reactive power compensation. Hence, they increase the availability and reliability of the power systems. But, the functioning of a FACTS device extremely reckons upon its parametric quantity, appropriate placement, and sizing in the power network. In this paper, an extensive literature survey is presented to discuss and investigate these parameters of FACTS devices.

show abstract

“…The interconnected parameters consist of current, stage point, voltage, damping of under-recurrence motions and, shunt and arrangement of impedances. Fast thyristors are used as FACTS gadgets to switch out and switch in transmission line compensators, like capacitors and reactors, and to stage movement of transformers for operations [17]. Figure 2 depicts how this is communicated by taking after condition.…”

Section: Fact's Devices Thyristor Controlled Series Capacitor (Tcsc)mentioning

confidence: 99%

Phase Measurement Units based FACT’s Devices for the Improvement of Power Systems Networks Controllability

Hussein¹,

Salman²,

Hasan³

2018

IJECE

View full text Add to dashboard Cite

This paper describes the importance of FACTS devices; it presents the outcome of the study of its reflectance on the performance of power system networks. It seeks to increase and guarantee the fact and accuracy of response systems under disturbance conditions when the phase measurement units are introduced as Real-Time Measurement (RTM) stations. This paper also describes the importance of FACTS devices. The combination of FACTS devices and PMUs is presented to increase the controllability performance of power systems. This paper demonstrates how PMUs measure voltage, current and their angles. It provides, through a communication link, a Phase Angle Data Concentrator (PDC) to make an appropriate decision to correct the power system state using the FACTS device (TCSC). We utilized the Graph-Theoretic Algorithm to optimize the number and location of PMUs. The technique proposed was tested on the Iraqi National Super Grid’s 24bus network, Diyala City’s regional 10bus network and the 14bus IEEE standard test system. The MATLAB/PSAT package was utilized for the simulation of results. It is evident that our proposed algorithm and technique achieved the purpose of this paper as confirmed by the level of accuracy of the results obtained from most of the cases tested.

show abstract

Determination of optimal location of TCSC and STATCOM for congestion management in deregulated power system

Cited by 22 publications

References 7 publications

A Comprehensive Review on Optimal Location and Sizing of Reactive Power Compensation Using Hybrid-Based Approaches for Power Loss Reduction, Voltage Stability Improvement, Voltage Profile Enhancement and Loadability Enhancement

A Comprehensive Review on Optimal Location and Sizing of Reactive Power Compensation Using Hybrid-Based Approaches for Power Loss Reduction, Voltage Stability Improvement, Voltage Profile Enhancement and Loadability Enhancement

Modeling, Control and Placement of FACTS Devices: A Review

Phase Measurement Units based FACT’s Devices for the Improvement of Power Systems Networks Controllability

Contact Info

Product

Resources

About