Detection and identification of gaseous organics using a TiO2 sensor

Skubal, Laura R.; Meshkov, N.K.; Vogt, Michael

doi:10.1016/s1010-6030(02)00079-5

Cited by 90 publications

(44 citation statements)

References 22 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…4 Because of the above reasons, mercury must be removed to very low levels from wastewater generated in industries such as metal smelting and caustic-chlorine production in mercury cells, metal processing, plating and metal finishing. 5 Numerous physical and chemical separation processes, such as solvent extraction, ion-exchange, precipitation, membrane separation, reverse osmosis, coagulation and photoreduction, [6][7][8][9] have been applied for effective reduction of mercury concentrations from various aqueous solutions.…”

Section: Introductionmentioning

confidence: 99%

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Hassan¹,

Kamel²,

Awwad³

et al. 2018

ECB

View full text Add to dashboard Cite

Decontamination of mercury from aqueous media remains a serious task for health and ecosystem protection. Removal of Hg(II) from the aqueous solution by ZnO:S has been investigated and elucidated. The effect of various parameters such as solution pH, adsorbent dose, contact time, initial adsorbate concentration has been studied and optimized. The optimized parameters for metal ion are pH value of 2.4, the equilibrium time was attained after 30 min, and the maximum removal percentage was achieved at an adsorbent loading weight of 0.08 g. It was found that the adsorption capacity of ZnO:S increased with increase in the initial mercury concentration. The equilibrium and kinetic data were found to be in good agreement with Freundlich isotherm model. * Corresponding AuthorsFax: +20 2 26822991 E-Mail: saadsmhassan@yahoo.com (S.S.M. Hassan) [a]

show abstract

Section: Introductionmentioning

confidence: 99%

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Hassan¹,

Kamel²,

Awwad³

et al. 2018

ECB

View full text Add to dashboard Cite

show abstract

“…to the purification of air and water from contaminants [1][2][3], in photoelectrical cells [4,5], or as gas sensor [6,7] appear to be very attractive. These processes are based on the feature that (nanocrystalline) TiO 2 is able to photocatalyze many organic substances under UV irradiation.…”

mentioning

confidence: 99%

Structural investigation of pristine and annealed nanocrystalline TiO₂ thin films by X‐ray diffraction and Raman spectroscopy

Orendorz

Brodyanski

Lösch

et al. 2007

Phys. Status Solidi (c)

View full text Add to dashboard Cite

Nanocrystalline anatase TiO 2 films were prepared from colloidal suspensions using particles with a nominal size of 12 nm. Their structure was examined by Raman spectroscopy and X-ray diffraction (XRD). The as-prepared specimens exhibit exclusively features due to the anatase phase of TiO 2 (e.g., the E g , B 1g and A 1g vibration modes in Raman spectroscopy and the characteristic diffraction peaks in XRD). Isochronal annealing of the films in air at temperatures of up to 1320 K effected clear structural changes, observed both in Raman and XRD: the crystallite size increases from ~13 nm to ~125 nm between 470 K and 1220 K, with the crystallites remaining in the anatase phase. A phase transition to the rutile phase of TiO 2 occurs gradually in the temperature range 1220 -1320 K and the average crystallite size increases to ~160 nm. The E g vibration in anatase films reveals a blue shift and an asymmetric peak broadening towards higher frequencies for smaller particle size/lower annealing temperatures. A power-law dependence between the Raman peak width and the inverse of the crystallite size is found.

show abstract

“…From the optical symptoms, then the screening process using TCS230 color sensor had to be done to count and excute a certain calibration. 6,7 Based on the image, it would be difficult to differentiate TB bacteria from other artifact that it needs some special ability regarding sputum staining.…”

Section: Resultsmentioning

confidence: 99%

Tuberculosis Counter (Tc) as the Equipment to Measure the Level of Tb in Sputum

Purwanda

Fibriawan

Sasmito

et al. 2016

IJTID

View full text Add to dashboard Cite

Tuberculosis (TB) is an infectious disease caused by Mycobacterium tuberculosis. This disease is the third killer disease after cardiovascular diseases and respiratory diseases, and is also he number one killer disease in a group of infectious diseases. This is partly due to the late handling and a non real time detection, both of which will inhibit the therapy which yields a large number of microorganisms in the body

show abstract

Detection and identification of gaseous organics using a TiO2 sensor

Cited by 90 publications

References 22 publications

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Structural investigation of pristine and annealed nanocrystalline TiO₂ thin films by X‐ray diffraction and Raman spectroscopy

Tuberculosis Counter (Tc) as the Equipment to Measure the Level of Tb in Sputum

Contact Info

Product

Resources

About

Detection and identification of gaseous organics using a TiO2 sensor

Cited by 90 publications

References 22 publications

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Adsorbent for Efficient Removal of Mercury(ii) From Aqueous Solution

Structural investigation of pristine and annealed nanocrystalline TiO2 thin films by X‐ray diffraction and Raman spectroscopy

Tuberculosis Counter (Tc) as the Equipment to Measure the Level of Tb in Sputum

Contact Info

Product

Resources

About

Structural investigation of pristine and annealed nanocrystalline TiO₂ thin films by X‐ray diffraction and Raman spectroscopy