Design of PV system for a Primary Distribution System under Loss and Voltage Drop Control Based on ETAP

Kraiprab, Somchai; Ratchapan, Ritthichai; Plangklang, Boonyang; Kongnok, Rungphet; Kongjeen, Yuttana; Kerdchuen, Kaan

doi:10.1109/ieecon53204.2022.9741673

Cited by 1 publication

(2 citation statements)

References 8 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Also, The losses network profile can be controlled through reactive power injection [6]. The standard limits stated in the grid code specify that the voltage should be within the range of -10 to +5 volts, and power factor should be greater than 0.85, Short circuit current should be below the breaking capacity of the equipment, THDv (Total Harmonic Distortion of voltage) should be less than 5%, and THDi (Total Harmonic Distortion of current) should be less than 3% [7].…”

Section: Literature Review and Methodologymentioning

confidence: 99%

See 1 more Smart Citation

The Impact of a 1.1 MWp PV Rooftop Integration in Medium Voltage Distribution Networks

Prasetya,

Sudiarto

2023

IJECBE

View full text Add to dashboard Cite

A high penetrating the capacity of Rooftop PLTS has an impact on the performance of distribution network operations and the prior technical studies only using simulation. This paper examines the impact of integrating a 1.1 MWp PV Rooftop into the medium voltage distribution network, involves a comparison between simulation data obtained using the ETAP software, before and after integration, compared with direct measurements. The results indicate improvements in the distribution operating performance. Following the integration, there was a 0.05% increase in voltage levels, a 0.06% increase in short circuit current, a 1.25% reduction in network losses, up to 8.9% harmonics current, up to 0.14% harmonics voltage, and a 0.28% decrease in power factor, as observed at both the substation and the network, they are in accordance with the measurement results.

show abstract

Section: Literature Review and Methodologymentioning

confidence: 99%

“…Meanwhile, the power loss is reduced to 5.06%. This can improve the efficiency of electric power [8].…”

Section: Methodsmentioning

confidence: 99%

The Impact of a 1.1 MWp PV Rooftop Integration in Medium Voltage Distribution Networks

Prasetya,

Sudiarto

2023

IJECBE

View full text Add to dashboard Cite

show abstract

Design of PV system for a Primary Distribution System under Loss and Voltage Drop Control Based on ETAP

Cited by 1 publication

References 8 publications

The Impact of a 1.1 MWp PV Rooftop Integration in Medium Voltage Distribution Networks

The Impact of a 1.1 MWp PV Rooftop Integration in Medium Voltage Distribution Networks

Contact Info

Product

Resources

About