Design of a 1-MV induction cavity and validation of the two-dimensional circuit model

Abstract

We present the design and test results of an induction cavity, which is a full-scale prototype cell of a prospective six-stage induction voltage adder. This induction cell runs in positive polarity and the output transmission line operates in the vacuum insulation state. The design methods and configurations of the azimuthal transmission line, insulation stack, magnetic core, cathode plate, and output transmission line in the induction cell are given in detail. The induction cavity is driven by one pulsed power system consisting of a tesla transformer, intermediate storage capacitor, laser triggered gas switch, pulse forming line, selfbreaking oil switch, and a water transmission line. A maximum voltage about 1.05 MV could be achieved across one 7.0 Ω water resistor load. A full circuit model including the primary energy storage section and pulse forming section is proposed. The circuit model also includes the two-dimensional circuit model of the induction cavity [Phys. Rev. Accel. Beams 20, 020401 (2017)]. The voltage and current waveforms across the feed port, azimuthal transmission line, insulation stack, and resistor load obtained during the experiment are compared with the circuit simulation results. It demonstrates that they can agree with each other very well.