Design, Measurement and Application of Lumped Elements up to J-Band

Pengelly, R.S.; Rickard, D.C.

doi:10.1109/euma.1977.332468

Cited by 23 publications

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Mondal [lo] reported a distributed model of the MIM capacitor based on the coupled line approach. Pengelly et al [11,12] presented the first extensive results on different lumped elements on GaAs, including inductors and interdigital capacitors, with special emphasis on Q-factor. Petten-Paul et al [13] reported the lumped element models using numerical solutions along with the basic microstrip theory and network analysis.…”

Section: Introductionmentioning

confidence: 99%

Cad compatible accurate models of microwave passive lumped elements for mmic applications

Sadhir

Bahl²,

Willems

1994

Int. J. Microw. Mill.‐Wave Comput.‐Aided Eng.

View full text Add to dashboard Cite

This article presents accurate measurement-based models derived from measured S-parameters of passive circuit elements which include inductors, thin-film resistors, interdigital and MIM capacitors, via holes, and airbridges for use in the computer-aided design of monolithic microwave integrated circuits (MMICs). The thru-reflect-line (TRL) calibration method is employed to accurately measure the S-parameters of the passive elements. Some of the models are scalable for different substrate thicknesses and substrate dielectric constant values as they are based on microstrip line theory.

show abstract

Section: Introductionmentioning

confidence: 99%

Cad compatible accurate models of microwave passive lumped elements for mmic applications

Sadhir

Bahl²,

Willems

1994

Int. J. Microw. Mill.‐Wave Comput.‐Aided Eng.

View full text Add to dashboard Cite

show abstract

Microwave Circuits

Gupta¹,

Cebi²,

Cho³

et al. 1999

Wiley Encyclopedia of Electrical and Electronics Engineering

View full text Add to dashboard Cite

The sections in this article are Types of Microwave Circuits Lumped and Distributed Circuits Evolution of Microwave Circuits Waveguide Circuits Coaxial Line Circuits Stripline Circuits Microstrip Circuits Coplanar Waveguide Circuits Lumped‐Element Circuits Multilayer Microwave Circuits Design of Microwave Circuits Emerging Trends In Microwave Circuits

show abstract

Microwave Circuits

Gupta¹,

Cebi²,

Cho³

et al. 2005

Encyclopedia of RF and Microwave Engineering

View full text Add to dashboard Cite

The term “microwave circuits” is used to identify the electrical circuits used at microwave frequencies for performing signal processing functions like amplification, frequency conversion, mixing, detection, phase shifting, filtering, and power dividing. By “microwave frequencies,” we refer to electromagnetic signals whose wavelength is in centimeters, roughly from 30 cm to 1 mm with the corresponding frequencies ranging from 1GHz (GHz=10 9 Hz) to 300 GHz. band. Microwave frequencies present several interesting and unusual features not found in other portions of the electromagnetic frequency spectrum. These features make microwaves uniquely suitable for several useful applications in telecommunications, radar, industrial heating and sensors, and so on. The most common consumer application of microwaves is the domestic microwave oven used for food processing.

show abstract

Design, Measurement and Application of Lumped Elements up to J-Band

Cited by 23 publications

References 3 publications

Cad compatible accurate models of microwave passive lumped elements for mmic applications

Cad compatible accurate models of microwave passive lumped elements for mmic applications

Microwave Circuits

Microwave Circuits

Contact Info

Product

Resources

About