Design and tuning of fixed-switching-frequency second-order sliding-mode controller for doubly fed induction generator power control

Susperregui, A.; Martinez, Miren Itsaso; Zubia, I.; Tapia, G.

doi:10.1049/iet-epa.2011.0358

Cited by 36 publications

(32 citation statements)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Application of second order SMC allows to retain the robustness characteristics of the first order SMC control algorithm at a fixed switching frequency. Additionally, possible chatter can be reduced [36].…”

Section: A Second Order Smc Current Regulatorsmentioning

confidence: 99%

See 2 more Smart Citations

PM-Assisted Synchronous Reluctance Machine Flux Weakening Control for EV and HEV Applications

Trancho

Ibarra

Arias

et al. 2018

IEEE Trans. Ind. Electron.

View full text Add to dashboard Cite

Section: A Second Order Smc Current Regulatorsmentioning

confidence: 99%

“…Aiming to achieve satisfactory tracking performance for i d and i q , the following sliding functions are adopted [36]: where…”

Section: A Second Order Smc Current Regulatorsmentioning

confidence: 99%

See 1 more Smart Citation

PM-Assisted Synchronous Reluctance Machine Flux Weakening Control for EV and HEV Applications

Trancho

Ibarra

Arias

et al. 2018

IEEE Trans. Ind. Electron.

View full text Add to dashboard Cite

“…Another second order SMC given in [4] achieves smooth connection of DFIG to the grid. Constant switching frequency second order SMC is achieved in [16]. There are also some other reputable studies which consider robustness against grid voltage problems [17] by proposing different phase-lock-loop (PLL) techniques to detect the voltage signal.…”

Section: Introductionmentioning

confidence: 99%

A Novel Current Controller Scheme for Doubly Fed Induction Generators

et al. 2015

View full text Add to dashboard Cite

Original scientific paperThis paper presents a novel current control methodology for grid connected doubly-fed induction generator (DFIG) based wind energy conversion systems. Controller is based on a proportional controller with additional first order low pass filter disturbance observer which estimates the parameter dependent nonlinear feed-forward terms. The results in simulations and experimental test bed obviously demonstrate that decoupled control of active and reactive power is achieved without the necessity of additional machine parameter. Key words: DFIG, Disturbance observer, Wind energyNovi regulator struje za dvostrano napajani asinkroni generator. U ovom radu prikazana je nova metoda upravljanja strujom za vjetroagregat s dvostrano napajanim asinkronim generatorom spojen na mrežu. Regulator se temelji na proporcionalnom regulatoru uz dodatak niskopropusnog fitra prvog reda za estimaciju poremećaja koji estimira parametarski ovisne nelinearne predupravljačkečlanove. Simulacijski i eksperimentalni rezultati pokazuju da je postignuto raspregnuto upravljanje radnom i jalovom snagom bez potrebe za dodatnim parametrima generatora.

show abstract

“…These controllers have satisfactory power response when compared with the PI ones, but it is hardly to implement them due to the predictive functional controller and internal mode controller formulation. Other possibilities to DFIG power control are fuzzy logic [15], [16], deadbeat [17], model based predictive control [18] or sliding mode control [19], [20]. In the same way, these strategies also have satisfactory ones, although it involves relatively complex transformation of voltages, currents, and control outputs among the stationary, rotor, and synchronous reference frames.…”

Section: Introductionmentioning

confidence: 99%