Design and simulation of Solar PV system

Dubey, Kartika; Shah, M. T.

doi:10.1109/icacdot.2016.7877649

Cited by 32 publications

(15 citation statements)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The rise in environmental temperature has the effect of increasing the close-circuit current but in a marginally smaller proportion which will have no contribution to a noticeable increase in PV panel power output as seen in Figure 11. To validate the performance and functionality of the designed test chamber, a comparison was made between the experimental results and MATLAB simulation result [12] as shown in Figure 12. These comparisons are shown in Figure 13.…”

Section: Resultsmentioning

confidence: 99%

Performance evaluation of Photovoltaic Panels by a Proposed Automated System Based on Microcontrollers

Ali¹,

Tapou²,

Dhahad³

2021

ETJ

View full text Add to dashboard Cite

In this paper, an automated test setup for PV panels using LabVIEW and several microcontrollers (µCs) based embedded systems has been designed, tested, and implemented. This PV testing system has been characterized as fully automated and the only human intervention required is to install the PV panel and to set the required testing conditions. Several PV panels were evaluated and tested, the obtained results showed a high degree of accuracy and conformity with several testing schemes that have been carried out numerically, manually and manufacturer specifications. The designed system is characterized by a high-performance standard with accuracy, precision, and resolution (9 mV / 1.8 mA) that is good enough to test any PV panel of 12 V and 24 V rating. This system can test and calculate the maximum power point for any PV panel operating at any given working condition by applying different amounts of solar irradiance from 0 W/m2 to 1000 W/m2 to simulate the amount of solar irradiation at any time and everywhere on earth. This system also mimics the environment temperature by providing ambient temperature ranged from 0 °C to 50 °C to simulate the variation of weather around the year.

show abstract

Section: Resultsmentioning

confidence: 99%

Performance evaluation of Photovoltaic Panels by a Proposed Automated System Based on Microcontrollers

Ali¹,

Tapou²,

Dhahad³

2021

ETJ

View full text Add to dashboard Cite

show abstract

“…). An inverter converts a DC input supply voltage into a symmetric AC voltage of desired magnitude and frequency [16]. The single-phase voltage source inverter in this system converts the fixed DC voltage (48 V) from the DC-DC boost converter into a single-phase AC voltage (48 V) with a fixed frequency of 50 Hz.…”

Section: Dc-ac Converter (Invertermentioning

confidence: 99%

Design and Dynamic Modelling of a Hybrid Power System for a House in Nigeria

Aghenta

Iqbal

2019

International Journal of Photoenergy

View full text Add to dashboard Cite

This paper presents the design and dynamic modelling of a hybrid power system for a house in Nigeria. Thermal modelling of the house under consideration is carried out using BEopt software to accurately study the heat loss through the walls, windows, doors, and roof of the house. The analysis of this thermal model is used to determine hourly load data. Design of an optimum hybrid power system for the house is done with HOMER Pro software. The hybrid power system is made up of a diesel generator and a stand-alone PV system. The proposed PV system consists of PV arrays, DC–DC boost converter, MPPT controller, single-phase full-bridge inverter, inverter voltage mode controller (PI controller), and single-phase step-up transformer. Dynamic simulation of the proposed PV system component of the hybrid power system is carried out in MATLAB/Simulink environment to study the power quality, harmonics, load impact, voltage transients, etc. of the system, and the simulation results are presented in the paper.

show abstract

“…The buck converter output voltage can be quite easily affected by variations from the system parameters [18]. Hence, the need for a control system which is capable of maintaining constant voltage notwithstanding any system distortion.…”

Section: Voltage Mode Controllermentioning

confidence: 99%

“…In this paper, the voltage mode controller was applied to the proposed system. This is due to the robustness of the system and its ease of application [18]. The voltage mode controller is, as shown in figure 12.…”

Section: Voltage Mode Controllermentioning

confidence: 99%

Sizing and dynamic modelling and simulation of a standalone PV based DC microgrid with battery storage system for a remote community in Nigeria

Ndukwe

Iqbal

2019

Journal of Energy Systems

View full text Add to dashboard Cite

In this paper, a solar PV powered DC microgrid is proposed and designed for Umuokpo Amumara in Nigeria with 800 households and a number of community installations which include churches, schools, shops, and a water pumping system. The appropriate sizes of system components are determined to meet the all-time load demand. A Techno-economic feasibility study was carried out in Homer Pro to determine the energy needs of the community and as well the system size and configuration that best suits the community. The energy requirement of the community was obtained to be 3.16MWh/day. The battery storage system was also sized in this work and a battery system capacity of 21,944Ah was able to meet the community energy requirement for up to a day without renewable energy supply. The dynamic model of proposed the microgrid was simulated in MATLAB/SIMULINK to observe the system's dynamic response in view of the power quality, load impact, and battery storage charging. The results obtained from the simulation depicted a stand-alone DC microgrid that is capable of meeting the daily electrical energy requirements of the system with good voltage stability. The PV system used in the system could function at maximum power conditions even with variation in the weather conditions. This was achieved by employing the Incremental Conductance MPPT system.

show abstract

Design and simulation of Solar PV system

Cited by 32 publications

References 3 publications

Performance evaluation of Photovoltaic Panels by a Proposed Automated System Based on Microcontrollers

Performance evaluation of Photovoltaic Panels by a Proposed Automated System Based on Microcontrollers

Design and Dynamic Modelling of a Hybrid Power System for a House in Nigeria

Sizing and dynamic modelling and simulation of a standalone PV based DC microgrid with battery storage system for a remote community in Nigeria

Contact Info

Product

Resources

About