Design and implementation of rotating speeds modulation for a certain type of engine

Li, Xin; Zhang, Yue; Bao, DongChen; Zhao, Jipeng

doi:10.1117/12.2624705

Cited by 2 publications

(1 citation statement)

References 0 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The voltage detected by the peak detector is defined as the VGS for FET. As shown in Figure 2, taking a rotating speed waveform of one type of engine as an example, the waveform could be approximately considered as a sinusoidal impulse with a disturbance of 20% duty cycle [9].…”

Section: Circuit Designmentioning

confidence: 99%

The Design and Simulation of Engine Rotating Speed Modulation of Circuit

Li,

Wang,

Cui

et al. 2023

J. Phys.: Conf. Ser.

View full text Add to dashboard Cite

Since the amplitude and frequency of engine rotating speed signals are changed with the engine rotating speed, data cannot be directly collected due to the high-frequency noise. In this work, an engine rotating speed modulation of the circuit was designed. It was used to retain the complete information of positive and negative periods in signals and convert rotating speed signals to rectangular wave signals with certain amplitude at the same frequency, which could be directly collected. Further, in order to investigate the applicability of our design, a simulation test on the developed circuit based on Multisim was performed. This indicates that the raw signal with high-frequency interference, different amplitudes, and frequencies could be accurately and efficiently converted to regular rectangular wave signals. The design is characterized by a compact structure, low difficulty in device selection, high stability, and low power consumption, which is of extreme significance for accurate rotating speed data collection.

show abstract

Section: Circuit Designmentioning

confidence: 99%