Design and implementation of reconfigurable virtual instruments using Raspberry Pi core

Sundaramurthy, R.; Nagarajan, V.

doi:10.1109/iccsp.2016.7754107

Cited by 5 publications

(1 citation statement)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Additionally, for Raspberry Pi research's, the following are highlighted: In [9] it is described the design and implementation of a reconfigurable virtual instrumentation equipment. With this kind of equipment, it is possible to emulate multiple functionalities like signal generators, oscilloscope, multimeter, logic analyzers, among others.…”

Section: Stage 1 Gathering Informationmentioning

confidence: 99%

Raspberry PI 3 RF signal generation system

2019

View full text Add to dashboard Cite

Radio frequency signal generators (RF) are instruments used to test reception equipment and RF components like filters, amplifiers, attenuators, among others. On the other hand, they reinforce the teaching-learning processes and they are widely used in research in the telecommunications field. This document provides the first stage of a low-cost signal generator design by using RaspBerry Pi 3, with the documentary exploration about this kind of applications. After that, a recognition of the RaspBerry Pi 3 is done at hardware and software level. Finally, an application of an FM signal generator with RaspBerry in a frequency of 101.3 MHz is evaluated, which does not require any additional hardware. This signal was captured using a spectrum analyzer, which determined good quality of the modulated signal in terms of power, bandwidth and SNR (Signal Noise Ratio). However, there are some unwanted harmonic components

show abstract

Section: Stage 1 Gathering Informationmentioning

confidence: 99%