Design and Hardware Implementation of SVC using Thyristorised Control for improving power factor and voltage profile of inductive loads

Pathak, Manan; Jamnani, Jitendra G.

doi:10.1109/icpes.2016.7584076

Cited by 5 publications

(3 citation statements)

References 11 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…TSC is used for different systems, including distribution systems. With time sequence of switches, they can be used to regulate voltage and compensate reactive power [10][11][12]. When a capacitor is connected by a sinuous voltage source, the current of capacitor will undergo severe fluctuation in case the initial voltage of the capacitor's two ends is higher than feed quantity.…”

Section: Parallel Capacitor Controlled By Thyristormentioning

confidence: 99%

Stabilization of Voltage and Current in the Distribution Networks using APF and TSC

2022

IJE

View full text Add to dashboard Cite

Instability of voltage is a problem that has been occurring in recent years due to excessive exploitation from equipment and an increase in demand for load across the distribution system. Shortage of the reactive power in the power networks, especially distribution networks, pushes the system toward voltage instability and leads to voltage drop as well as voltage fluctuations in the feeder. One of the potential solutions for compensation is to install thyristor switched capacitor (TSC). Although TSC can reduce the total costs of compensation, the static error will reduce compensation. For this purpose, an active power filter (APF) can be applied to resolve errors resulting from TSC due to features of continuous compensation and quick dynamic response. In this research, the combined method was presented, including TSC and APF of a controllable active power injection and with appropriate switching based on the study of voltage drop in the radial distribution networks and improvement of power quality. The suggested model was executed by MATLAB software, whereby results of improvement and provision of the stability conditions (dynamic and static) of voltage and current were observed.

show abstract

Section: Parallel Capacitor Controlled By Thyristormentioning

confidence: 99%

Stabilization of Voltage and Current in the Distribution Networks using APF and TSC

2022

IJE

View full text Add to dashboard Cite

show abstract

“…The thyristor control circuit for SVC is proposed for power factor correction and voltage improvement at static and dynamic loads conditions. Results of the measured power factor and voltage from software and hardware were compared17 [17].…”

Section: Introductionmentioning

confidence: 99%

“…'Imq(n−1)' is the amplitude of the quadrature component of source current at (n-1)th instant. The quadrature component of the reference current is presented in eq(17).…”

mentioning

confidence: 99%

Micro-Grid Stability Improvement Using Static Synchronous Compensator Assisted with Battery Energy Storage System

2020

SJET

View full text Add to dashboard Cite

The Method of Power Factor Calculation under Non-Sinusoidal Conditions

Sychev

Aladin

Abramovich

2020

2020 IEEE Conference of Russian Young Researchers in Electrical and Electronic Engineering (EIConRus)

View full text Add to dashboard Cite

Design and Hardware Implementation of SVC using Thyristorised Control for improving power factor and voltage profile of inductive loads

Cited by 5 publications

References 11 publications

Stabilization of Voltage and Current in the Distribution Networks using APF and TSC

Stabilization of Voltage and Current in the Distribution Networks using APF and TSC

Micro-Grid Stability Improvement Using Static Synchronous Compensator Assisted with Battery Energy Storage System

The Method of Power Factor Calculation under Non-Sinusoidal Conditions

Contact Info

Product

Resources

About