Design and fabrication of silicon condenser microphone using corrugated diaphragm technique

Abstract

A novel silicon condenser microphone with a corrugated diaphragm has been proposed, designed, fabricated and tested. The microphone is fabricated on a single wafer by use of silicon anisotropic etching and sacrificial layer etching techniques, so that no bonding techniques are required. The introduction of well-performing corrugations has greatly increased the mechanical sensitivities of the microphone diaphragms due to the reduction of the initial stress in the thin fdms. For the purpose of further decreasing the thin film stress, composite diaphragms consisting of multilayer (polySi/Siz N,/polySi) materials have been fabricated, reducing the initial stress to a much lower level of about 70 MPa in tension. Three types of corrugation placements and several corrugation depths in a diaphragm area of 1 mm2 have been designed and fabricated. Microphones with flat frequency response between 100 Hz and 8-16 kHz and opencircuit sensitivities as high as 8.1-14.2 mV/Pa under the bias voltages of 10-25 V have been fabricated in a reproducible way. The experimental results proved that the corrugation technique is promising for silicon condenser microphone. [185]

Fabrication of a dual-planar-coil dynamic microphone by MEMS techniques

“…Therefore, the magnetic potential can be solved by using the finite element method, while the magnetic flux density can be computed from equation (5) and becomes…”

“…Although, with high sensitivity and good frequency response, condenser microphones become one of the mainstream choices; however, they are merely preferred in the applications of high-quality studio recording and the laboratory due to high self-noise, high internal impedance and the requirement of an external power supply to maintain a nearly constant electric charge on two plates. Moreover, in the last decade, miniature condenser microphones based on silicon micromachining techniques were the subject of research and development [4,5]. Silicon-based condenser microphones are widely recognized as the next-generation product to replace the conventional electret condenser microphone (ECM).…”

Two clover-shaped piezoresistive silicon microphones for photo acoustic gas sensors

“…The design of high compliance structures for microphones can be divided into two classes: the design of high compliance membranes and suspension schemes for released membranes. Solid high-compliance membranes are commonly designed through adding corrugations [21,[43][44][45][46][47]. Several released membranes with various suspension schemes can be found in the literature.…”

Design and simulation of miniature ribbon microphones

“…In the last decade, miniature microphones based on silicon micromachining techniques were the subject of research and development. 1,2 Silicon microphones are widely recognized as the next-generation product to replace the conventional electret condenser microphone ͑ECM͒. Most silicon microphones are condenser microphones because of their potential advantages in terms of miniaturization, high sensitivity, low noise level, environmental endurance, mass production capability, and flat frequency responses in a wide bandwidth.…”