Design and Decomposition Analysis of Mixing Zone Structures on Flame Dynamics for a Swirl Burner

Abstract

The recirculation zone and the swirl flame behavior can be influenced by the burner exit shape, and few studies have been made into this structure. Large eddy simulation was carried out on 16 cases to distinguish critical geometry factors. The time series of the heat release rate were decomposed using seasonal-trend decomposition procedure to exclude the effect of short physical time. Dynamic mode decomposition (DMD) was performed to separate flame structures. The frequency characteristics extracted from the DMD modes were compared with those from the flame transfer functions. Results show that the flame cases can be categorized into three types, all of which are controlled by a specific geometric parameter. Except one type of flame, they show nonstationary behavior by the Kwiatkowski–Phillips–Schmidt–Shin test. The frequency bands corresponding to the coherent structures are identified. The flame transfer function indicates that the flame can respond to external excitation in the frequency range 100–300 Hz. The DMD modes capture the detailed flame structures. The higher frequency bands can be interpolated as the streamwise vortices and shedding vortices. The DMD modes, which correspond to the bands of flame transfer functions, can be estimated as streamwise vortices at the edges.

Casting Machines in Dentistry – A Review Part I

“…A correctly calibrated torch will generate an appropriate temperature of 1000°C for dental alloys with melting ranges within this temperature range. When the correct ratio of gas and air is blended and ignited, the resulting flame will display distinct zones of flames/combustion areas[ 15 ] [ Table 1 and Figure 2 ].…”