Design and analysis of a high-power radial multi-way combiner

This paper examines some important relationships, related with the system efficiency, for very high power, radio frequency solid-state transmitter; incorporating multiple solid-state power amplifier modules, power combiners, dividers, couplers, and control/interlock hardware. In particular, the characterization of such transmitters, at the component as well as the system level, is discussed. The analysis for studying the influence of the amplitude and phase imbalance, on useful performance parameters like system efficiency and power distribution is performed. This analysis is based on a scattering parameter model. This model serves as a template for fine-tuning the results, with the help of a system level simulator. For experimental study, this approach is applied to a recently designed modular and scalable solid-state transmitter, operating at the centre frequency of 505.8 MHz and capable of delivering a continuous power of 75 kW. Such first time presented, system level study and experimental characterization for the real time operation will be useful for the high power solid-state amplifier designs, deployed in particle accelerators.

System efficiency analysis for high power solid state radio frequency transmitter

Jain

Sharma

Gupta

et al. 2014

Experiments of a monolithic radial transmission line

Mao

Wang

Zou

et al. 2016

This paper presents the experimental results of a monolithic radial transmission line (MRTL) that may be used in pulsed power generators and microwave devices. The MRTL with a hyperbolic impedance profile is 508 mm in radius, corresponding to a one-way transit time of 15 ns for the electromagnetic wave. In the experiments, up to twenty identical voltage pulses, 10 ns in FWHM and 2 ns in rise-time, were fed into the MRTL through 20 input BNC connectors that are uniformly distributed along the outer circumference of the MRTL. It was found that the amplitude of the voltage from the output BNC connector located in the center of the MRTL is nearly proportional to the total number of the input branches. The effect of the failure modes on the output voltage was investigated. For the MRTL driven by 20 input branches, while the open-circuit or short-circuit even in one input branch considerably decreases the amplitude of the output voltage, the jitter shorter than 2 ns in 3 input branches makes no obvious effect on the output voltage.

High-power solid-state amplifier for superconducting radio frequency cavity test facility

Jain

Sharma

Gupta

et al. 2021

A horizontal test facility is set up at the Raja Ramanna Centre for Advanced Technology to test the superconducting radio frequency dressed cavities. Along with the cryomodule, control instrumentation, and the power coupler, this facility incorporates a high-power solid-state amplifier for establishing the desired cavity voltage gradient during the testing. This article describes the design, construction, rigorous testing, and measured results of this high-power solid-state radio frequency amplifier and its constituent components. Its maximum output power is 36 kW (average) at the operating frequency of 650 MHz. Its main features are its modular and scalable design with in-house developed constituent components. These components include 500 W, 20 dB gain modules, novel two-tier radial dividers, combiners, power sensors, and aperture-coupled directional couplers. Their excellent reprise performance for the multiple quantities confirms the design methodology presented here. The measured wall plug efficiency of this 36 kW amplifier is 43.6%, and its power gain is 86 dB. The designed radial combiner is highly efficient (power-combining efficiency of 98.4%), and the directional coupler exhibits a very low loss (insertion loss of 0.05 dB).