Design an efficient photoelectrochemical aptasensor for PCB72 based on CdTe@CdS core@shell quantum dots-decorated TiO2 nanotubes

Combination of alkali treatment and Ag3PO4 loading effectively improves the photocatalytic activity of TiO2 nanoflowers

“…It can be seen that there are two characteristic peaks at 530.87 eV and 529.54 eV corresponding to the Ti-OH and Ti-O bonds, respectively. [39][40][41] Fig. 4c shows the O 1s spectrum of Ag 3 PO 4 /OH/TiO 2 ; compared to the O 1s spectrum of TiO 2 , two new characteristic peaks appeared at 531.02 eV and 532.93 eV, corresponding to P-O and Ti-O-Ag bonds, which are caused by the loading of Ag 3 PO 4 .…”

Photoelectrochemical aptamer sensor based on AgInS2 and ZnS co-sensitized TiO2 for the detection of Hg2+

“…Liao et al constructed a PEC aptamer sensor based on CdTe@CdS QD-modified TiO 2 nanotubes. 26 Quantum dots (QDs), also known as semiconductor nanocrystals, are of interest for research in biosensing and medical imaging. Among them, ternary I–III–VI 2 compound quantum dots have recently become popular among researchers because of their excellent composition-dependent optical properties and biocompatibility.…”

CRISPR/Cas12a-Derived Photoelectrochemical Aptasensor Based on Au Nanoparticle-Attached CdS/UiO-66-NH2 Heterostructures for the Rapid and Sensitive Detection of Ochratoxin A

“…Recently, photoelectrochemical (PEC) aptasensors employing aptamers (Apts) as a biorecognition unit have attracted much attention with the merits of high sensitivity, simplicity, and low cost. 11,12 The PEC aptasensors converted bioreactioninduced responses into photocurrent or photovoltage signals.…”

“…Recently, photoelectrochemical (PEC) aptasensors employing aptamers (Apts) as a biorecognition unit have attracted much attention with the merits of high sensitivity, simplicity, and low cost. , The PEC aptasensors converted bioreaction-induced responses into photocurrent or photovoltage signals. In general, incorporating efficient photoactive materials into the sensing interface is crucial to improving the sensitivity of the sensor.…”