Depth‐encoding using optical photon TOF in a prism‐PET detector with tapered crystals

Abstract

BackgroundHigh‐resolution brain positron emission tomography (PET) scanner is emerging as a significant and transformative non‐invasive neuroimaging tool to advance neuroscience research as well as improve diagnosis and treatment in neurology and psychiatry. Time‐of‐flight (TOF) and depth‐of‐interaction (DOI) information provide markedly higher PET imaging performance by increasing image signal‐to‐noise ratio and mitigating spatial resolution degradation due to parallax error, respectively. PET detector modules that utilize light sharing can inherently carry DOI information from the multiple timestamps that are generated per gamma event. The difference between two timestamps that are triggered by scintillation photons traveling in opposite directions signifies the event's depth‐dependent optical photon TOF (oTOF). However, light leak at the crystal‐readout interface substantially degrades the resolution of this oTOF‐based depth encoding.PurposeWe demonstrate the feasibility of oTOF‐based depth encoding by mitigating light leak in single‐ended‐readout Prism‐PET detector modules using tapered crystals. Minimizing light leak also improved both energy‐based DOI and coincidence timing resolutions.MethodsThe tapered Prism‐PET module consists of a 16 16 array of 1.5 1.5 20 lutetium yttrium oxyorthosillicate (LYSO) crystals, which are tapered down to 1.2 1.2 at the crystal‐readout interface. The LYSO array couples 4‐to‐1 to an 8 8 array of 3 3 silicon photomultiplier (SiPM) pixels on the tapered end and to a segmented prismatoid light guide array on the opposite end. Performance of tapered and non‐tapered Prism‐PET detectors was experimentally characterized and evaluated by measuring flood histogram, energy resolution, energy‐, and oTOF‐based DOI resolutions, and coincidence timing resolution. Sensitivities of scanners using different Prism‐PET detector designs were simulated using Geant4 application for tomographic emission (GATE).ResultsFor the tapered (non‐tapered) Prism‐PET module, the measured full width at half maximum (FWHM) energy, timing, energy‐based DOI, and oTOF‐based DOI resolutions were 8.88 (11.18)%, 243 (286) ps, 2.35 (3.18) mm, and 5.42 (13.87) mm, respectively. The scanner sensitivities using non‐tapered and tapered crystals, and 10 rings of detector modules, were simulated to be 30.9 and 29.5 kcps/MBq, respectively.ConclusionsThe tapered Prism‐PET module with minimized light leak enabled the first experimental report of oTOF‐based depth encoding at the detector module level. It also enabled the utilization of thinner (i.e., 0.1 mm) inter‐crystal spacing with barium sulfate as the reflector while also improving energy‐based DOI and timing resolutions.