Dependence of Electrical Conductivity on Phase Morphology for Graphene Selectively Located at the Interface of Polypropylene/Polyethylene Composites

Abstract

Conductive composites of polypropylene (PP) and polyethylene (PE) filled with thermally reduced graphene oxide (TRG) were prepared using two different processing sequences. One was a one-step processing method in which the TRG was simultaneously melt blended with PE and PP, called TRG/PP/PE. The second was a two-step processing method in which the TRG and the PP were mixed first, and then the (TRG/PP) masterbatch was blended with PE, called (TRG/PP)/PE. The phase morphology and localization of the TRG in TRG/PP/PE and (TRG/PP)/PE composites with different PP/PE compositions were observed by transmission electron microscopy (TEM) and scanning electron microscopy (SEM). The TRG was found to be selectively dispersed in the PE phase of the TRG/PP/PE composites, resulting in a low percolation threshold near 2.0 wt%. In the (TRG/PP)/PE composites, the TRG was selectively located at the PP/PE blend interface, resulting in a percolation threshold that was lower than 1.0 wt%. With the addition of 2.0 wt% TRG, the (TRG/PP)/PE composites exhibited a wide range of electrical conductivities at PP/PE weight ratios of 10 w/90 w to 80 w/20 w. Moreover, electrical and rheological measurements of the composites revealed that the co-continuous phase structure is the most efficient candidate for the fabrication of conductive composites.

Near-Field Radiative Heat Transfer Between Out-of-Phase Graphene-Covered Silica

“…This, in turn, impacts the spectral distribution of the heat transfer and can result in significant enhancements or suppressions compared to in-phase or non-interacting graphene configurations. The energy-dependent conductivity of graphene can be related to its relaxation time τ and Fermi energy EF using the equation (S. Biehs, 2011) (Ce Tu, 2022:…”

Entropy Barrier Mitigation and Harnessing Localized Upcycled Graphene Nanoplatelets in Polypropylene/High-Density Polyethylene Nanoblends

“…The effectiveness of RGO in reducing the interfacial tension between the two polymers and promoting compatibilization suggests its potential as a viable substitute for traditional compatibilizers when blending otherwise incompatible polymers. In another study, thermally reduced graphene oxide (TRG) was selectively localized at the interface of the PP and PE blend by tailoring processing sequences [15]. The lower interfacial tension of TRG with PE prompts its localization in PE within the PP/PE blend; however, when subjected to pre-blending with PP followed by the addition of PE, it can be localized at the interface.…”

Mouldable Conductive Plastic with Optimised Mechanical Properties

“…A second approach is to use an immiscible polymer blend instead of a single polymer as the matrix to achieve the segregated network, through the concept of 'double percolation' [6,7]. Depending on thermodynamic properties, the filler might (1) distribute evenly in the two phases, in which case there is no advantage over a single polymer; (2) have preference to be one polymer phase than the other; or (3) it may segregate and concentrate in the regions between the two-phase boundaries leading to connectivity at low concentrations.…”