Density and refractive index of silica aerogels after low- and high-temperature supercritical drying and thermal treatment

Abstract

This paper reports on the density of silica aerogels after low-and high-temperature supercritical drying as well as on the corresponding optical refractive index. The influence of adsorbed water or methanol has also been investigated. Aerogel samples are prepared via soI3el process of pH 11 and pH 13 tetramethoxysilanehnethanolfwater solutions using ammonia as catalyst. After high-temperature drying, the pH 11 aerogels show volume shrinkage of less than lo%, while pH 13 aerogels and aerogels dried at low temperature with carbon dioxide shrink by about 50%. A linear relationship between refractive index and density is observed. Its slope is (0.221 f 0.002) x m3 kg-' and (0.193 f 0.002) x m3 kg-' before and after thermal treatment at 500°C for 14 h in air, respectively. The larger value is due to hydroxyl or methoxy groups in the aerogel. Adsorbed water or methanol cause the index to increase, as do molecules. The distribution of Si02 on the nanoscoDic level does not influence the index.

Versatile liquid-core optofluidic waveguides fabricated in hydrophobic silica aerogels by femtosecond-laser ablation

“…Within this formalism, Wang et al [29] determined the effective refractive index of silica aerogels as:…”

Radiative properties of materials with surface scattering or volume scattering: A review

“…The dips around 1400 and 1900 nm are attributed to absorption bands of residual water. The refractive index of aerogel is dependent on the bulk density as n&1 + 0.21ρ, where ρ is the bulk density, g/cm 3 [134]. Since aerogel is usually very light, its refractive index should be close to 1.…”

Pulsed THZ Interrogation of Sofi With Knit Lines in 2D

“…In [3], the effective index of refraction n e was approximated via the classical Claussius-Mossotti equation (for instance, see [7] and [8]), by assuming the total polarizability is the sum of the two polarizabilities in each part of the material. The index of refraction in each part of the foam was esti- mated to be…”