Dense Mulliteceramic Sintered by SPS and Its Behavior Under Thermal Shock

Wang, Pengfei; Luo, Xudong; Wei, Sai; Xie, Zhihui; Sun, Jia

doi:10.1007/s11148-018-0179-3

Cited by 1 publication

(1 citation statement)

References 15 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…10,11 Mullite is synthesized by various methods to solve the problem of scarcity in nature. 12,13 Wang et al 14 synthesized mullite ceramics with Al 2 O 3 and SiO 2 by using spark plasma sintering (SPS). The samples exhibited improved mechanical properties.…”

Section: Introductionmentioning

confidence: 99%

Synthesis and mechanical properties of mullite ceramics with coal gangue and wastes refractory as raw materials

Liu

Lian

et al. 2019

Int J Applied Ceramic Tech

View full text Add to dashboard Cite

With coal gangue and high alumina refractory solid wastes as raw materials, needle-like mullite powder, with an average diameter of about 1 μm, was synthesized at 1300°C by using the conventional solid-state reaction method. Mullite ceramics were derived from the inexpensive needle-like powder. Phase composition was examined by using X-ray diffraction (XRD), while morphologies of the ceramics were observed by using scanning electron microscopy. The content and distribution of elements in the sintered samples were characterized with energy dispersive spectrometer and X-ray fluorescence spectroscopy. Mechanical properties of the mullite ceramics were studied by using the three-point bending method. The aspect ratio of the needle-like mullite particles was up to 6. The mullite sample sintered at 1500°C for 3 hours had a density of 2.515 g•cm −3 , which was slightly lower than the theoretical density. Maximum fracture toughness and bending strength of the mullite ceramics were 1.82 MPa•m 1/2 and 71.76 MPa, respectively. This study realizes the resource utilization of gangue and high alumina refractory solid wastes, and the prepared mullite ceramics have good application prospect.

show abstract