Demonstration of a 100-mJ OPO/OPA for future lidar applications and laser-induced damage threshold testing of optical components for MERLIN

Abstract

Abstract. In the field of atmospheric research, lidar is a powerful technology that can measure gas or aerosol concentrations, wind speed, or temperature profiles remotely. To conduct such measurements globally, spaceborne systems are advantageous. Pulse energies in the 100-mJ range are required to achieve highly accurate, longitudinal resolved measurements. Measuring concentrations of specific gases, such as CH 4 or CO 2 , requires output wavelengths in the IR-B, which can be addressed by optical-parametric frequency conversion. An OPO/ OPA frequency conversion setup was designed and built as a demonstration module to address the 1.6-μm range. The pump laser is an Nd:YAG-MOPA system, consisting of a stable oscillator and two subsequent Innoslab-based amplifier stages that deliver up to 500 mJ of output pulse energy at 100 Hz repetition frequency. The OPO is inherited from the OPO design for the CH 4 lidar instrument on the French-German climate satellite methane remote-sensing lidar mission (MERLIN). To address the 100-mJ regime, the OPO output beam is amplified in a subsequent multistage OPA. With potassium titanyl phosphate as nonlinear medium, the OPO/OPA delivered more than 100 mJ of output energy at 1645 nm from 450 mJ of the pump energy and a pump pulse duration of 30 ns. This corresponds to a quantum conversion efficiency of about 25%. In addition to demonstrating optical performance for future lidar systems, this laser will be part of a laser-induced damage thresholds test facility, which will be used to qualify optical components especially for the MERLIN. © The Authors.Published by SPIE under a Creative Commons Attribution 3.0 Unported License. Distribution or reproduction of this work in whole or in part requires full attribution of the original publication, including its DOI.

High Energy Parametric Laser Source and Frequency-Comb-Based Wavelength Reference for CO2 and Water Vapor DIAL in the 2 µm Region: Design and Pre-Development Experimentations

“…This gain reduction, as well as reflection losses at the crystal faces, are assumed to account for the actual experimental outcome. Indeed, in previous works, a reduced gain by a factor of 1.5 was measured in a single-mode seeded OPA if the pump laser was switched from multi-to single-longitudinal-mode operation [54]. Moreover, our nonlinear crystals were operated at room temperature, close to 20 °C, thus out of the ideal phase-matching temperature, degrading the nonlinear gain of around 55% compared with the theoretical plane-wave non-saturated case.…”

A scalable thin-film defect quantify model under imbalanced regression and classification task based on computer vision

“…Therefore, detection of coating damage morphology is a very common need in production and research [ [20] , [21] , [22] , [23] ]. The currently available detection means are divided into two main types, one is to use an expert detection system customized based on computer vision to determine the damage pattern through a combination of complex algorithms and a large amount of a priori knowledge [ 24 , 25 ].…”

Earthquake-Damaged Regions Detection From High Resolution Image Based on Super-Pixel Segmentation and Deep Learning

“…Based on new remote sensing technologies such as Synthetic Aperture Radar (SAR), Light Detection and ranging (LIDAR), and Unmanned Aerial Vehicle (UAV) photography, the capability of multi-platform, multi-sensor, multi-scale and multi-angle observation is further improved (Chen et al 2016;Chiang et al 2017). Benefited from a wealth of data sources, many studies have presented assessment techniques for earthquake building damage by using different images (Elsen et al 2017;Endo et al 2018). Change detection based on pre-and post-disaster image was mostly used approach in damage detection, which was convenient and effective enough (Huang et al 2018).…”