Deformations in adhesively bonded joints on elastic foundations

Shahin, Khaled; Taheri‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬‬, Farid

doi:10.1016/j.compstruct.2009.02.011

Cited by 7 publications

(2 citation statements)

References 24 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In the fracture mechanics approach, failure of the adhesive is expressed in terms of the critical values of strain energy release rate [12,13] or other fracture parameters. Suo and Huchinson [14] analysed the strain energy release rate between two elastic layers, and their cracked-beam model (CBM) has been adopted for the analysis of fracture in single-lap joints [15] and cracked lap-shear joints [16,17]. Besides, an experimental study was performed by Min-Gyu Song et al to determine strength and fracture of adhesively bonded joints with their effects of manufacturing types on the joint strength.…”

Section: Introductionmentioning

confidence: 99%

Effect of Riveting on the Joint Strength of Adhesively Bonded Double Lap Joints

Solmaz¹,

Kocabaş²,

Gür³

2017

ANADOLU UNIVERSITY JOURNAL OF SCIENCE AND TECHNOLOGY a - Applied Sciences and Engineering

View full text Add to dashboard Cite

The scope of this study is to determine the effectiveness of using rivets in the adhesive joints in order to combine plastic-based composite materials which are often used in today's engineering structures, to the joint strength. For this purpose, double lap joints are prepared in 3 different types of configuration included adhesive, pinned and both adhesive and pinned and also prepared in 3 different overlap lengths as 30, 45 and 60 mm. Stress-strain diagrams were derived by exposing the joints obtained, to the axial tensile test and then the most appropriate joint type was determined by comparing each of the results obtained. The evaluation of the results pointed out that the hybrid joints where adhesive and rivet are used together can carry much more load than the joints where the only adhesive was used or the joints which are combined with a rivet in terms of joint strength.

show abstract

Section: Introductionmentioning

confidence: 99%

Effect of Riveting on the Joint Strength of Adhesively Bonded Double Lap Joints

Solmaz¹,

Kocabaş²,

Gür³

2017

ANADOLU UNIVERSITY JOURNAL OF SCIENCE AND TECHNOLOGY a - Applied Sciences and Engineering

View full text Add to dashboard Cite

show abstract

“…He assumed shear deformation constant across the adhesive thickness. Shahin and Taheri (2009), presented analytical treatment of the deformations in adhesively-bonded joints on elastic foundation with special attention to the specific case of adhesive joint between the face sheets of sandwich beams. They studied single-lap, stiffened and single strap joints using strain energy method.…”

mentioning

confidence: 99%

Theoretical Analysis of Stress Distribution in Bonded Single Strap and Stiffened Joints

Ghoddous

2017

Lat. Am. j. solids struct.

View full text Add to dashboard Cite

In this paper, distribution of peeling stress in two types of adhesively-bonded joints is investigated. The joints are a single strap and a stiffened joint. Theses joints are under uniform tensile load and materials are assumed orthotropic. Layers can be identical or different in mechanical or geometrical properties. A twodimensional elasticity theory that includes the complete stressstrain and the complete strain-displacement relations for adhesive and adherends is used in this analysis. The displacement is assumed to be linear in the adhesive layer. A set of differential equations was derived and solved by using appropriate boundary conditions. Results revealed that the peak peeling stress developed within the adhesive layer is a function of geometrical and mechanical properties. FEM solution is used as the second method to verify the analytical results. A good agreement is observed between analytical and FEM solutions.

show abstract