Deformation behavior of composites based on low-density polyethylene and hollow glass spheres

Polyolefin composites were prepared from 14 PE matrices and three different mineral fillers (montmorillonite, palygorskite and glass microspheres) via melt compounding in an extruder. Mechanical properties of the obtained systems were analyzed with emphasis on elongation at break and conditions for ductile/brittle failure were determined. When filler content is raised beyond a certain "critical" value, tensile properties are dramatically altered and transition occurs from ductile behavior to brittle fracture. This transition is displayed by a well-defined "step" on the plot of strain at break versus concentration of particles. The value of "critical filler content" was found to depend mainly on level of crystallinity of a matrix while other parameters (chemical nature of filler particles, their size, shape and surface treatment) are less significant. "Critical filler content" will decrease with growth of crystallinity of a polymer and with highly crystalline HDPEs it is as low as 2-8 vol %. Otherwise, with noncrystallizing and low-crystalline polymers elongation at break decreases gradually with concentration of mineral particles and ductile type deformation is maintained at fairly large filler fractions. The results presented here will be useful for a proper selection of a matrix polymer in composites with mineral fillers.

show abstract

“…GS are traditionally used to obtain concentration dependencies of mechanical characteristics of polymer composites. 19,20 …”

Section: Introductionmentioning

confidence: 98%