Deformation and Acoustic Emission Characteristics of Cracked Granite during Creep

Wang, Chunping; Xie, Jiacheng; Liu, Jian

doi:10.1155/2020/7075287

Cited by 3 publications

(2 citation statements)

References 19 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Some studies on surrounding rock failure use methods such as experimental tests, mechanical analyses, acoustic emissions, and numerical simulation [ 8 , 9 , 10 , 11 , 12 ]. Among them, acoustic emission (AE) could provide information about the development of cracks, and is helpful for understanding and predicting rock mass failure [ 13 , 14 , 15 , 16 , 17 ].…”

Section: Introductionmentioning

confidence: 99%

Analysis of Acoustic Emission Characteristics and Failure Mode of Deep Surrounding Rock of Sanshandao Gold Mine

et al. 2022

IJERPH

View full text Add to dashboard Cite

In mining engineering, crack distribution has a considerable influence on the mechanical behavior and stability of the surrounding rock mass. Using the granite of the Sanshandao gold mine as experimental samples, the deformation and failure of fractured rock were analyzed based on a rock uniaxial compression test with acoustic emission monitoring. We analyzed the characteristics of different stages of rock sample deformation, and evaluated the failure mode of seven types of rock samples. The results show that the cracks had a considerable impact on rock sample strength and mechanical behavior, and the strength of intact rock was the highest, while that of the sample with parallel double cracks was the lowest. The acoustic emission parameters, AF, RA, and lg(AF/RA), have different change trends in different stages of rock deformation and failure. Based on these change trends, the failure modes of rock samples with different crack distributions were identified. Additionally, for the rock samples with seven types of crack distribution, a sudden or progressive failure caused by the b-value curves was observed. The research findings provide a database for deep surrounding rock stability in the study area and provide suggestions for failure prediction.

show abstract

Section: Introductionmentioning

confidence: 99%

Analysis of Acoustic Emission Characteristics and Failure Mode of Deep Surrounding Rock of Sanshandao Gold Mine

et al. 2022

IJERPH

View full text Add to dashboard Cite

show abstract

“…On the other hand, due to the influence of geostress and gas pressure during the outburst process, crack initiation and development behaviors inside the coal rocks produce the acoustic emission (AE) phenomenon. As a result, AE monitoring which is a research method for studying and predicting deformation and failure of materials is introduced into monitoring and forecasting coal and gas outburst incidents [13,14]. It is proved to be an effective method to analyze the mechanism of coal and gas outbursts.…”

Section: Introductionmentioning

confidence: 99%

Experimental Research on Coal and Gas Delay Outburst and AE Characteristics under Conditions of Geostress and Gas Pressure Disturbance

Geng

Liu

et al. 2021

Advances in Materials Science and Engineering

View full text Add to dashboard Cite

Adopting yellow mud as barrier layer materials, coal and gas delay outburst experiments under conditions of geostress and gas accumulation disturbance were carried out by using self-developed simulation system, to find out roles of geostress and gas pressure played in the process of the delay outburst and ways to predict it, through analysis of variations of gas pressure, and AE characteristics during the process. The results show that after the geostress increased by 0.11 MPa from 1.80 MPa, an outburst occurs, while in gas accumulation situations, the gas pressure increase of 0.27 MPa from 0.67 MPa induces an outburst; hence, geostress is one of the dominant factors impacting an outburst occurrence. The lasting time of the outburst triggering under geostress disturbance is shorter than that under gas accumulation disturbance, while the duration of the outburst development under gas accumulation conditions is longer than that under geostress conditions. Coal seam breakage by geostress is the precondition for an outburst risk, and gas expansion energy is the dominant parameter influencing the duration of the outburst development. The AE signals show distinctive features in different stages of the outburst under geostress disturbance. At the preparation stage of the outburst, the AE signals increase sharply but have a low intensity and then drop to a lower balance level. At the triggering stage, the AE signals become active and increasing until up to the peak where the outburst occurs, and the intensity is highest.

show abstract

A novel time-dependent damage constitutive model for hard rock materials

Wang,

Yang,

Zhang

2023

Geomech. Geophys. Geo-energ. Geo-resour.

View full text Add to dashboard Cite

The mechanical behavior of deep hard rocks plays a crucial role in the long-term safety and stability of engineering structures. This work focuses on studying the instantaneous and time-dependent fracture propagation of hard rock materials from a theoretical perspective. A new unified constitutive model, based on a modified Mohr–Coulomb (M-C) criterion, is proposed to accurately represent the short and long-term mechanical properties of hard rocks. To capture the strain hardening and strain softening behaviors, damage is utilized as an internal mechanism-driven variable, controlling the expansion and contraction of the plastic yield surface. Additionally, a combination of time-dependent damage law and viscoplastic theory is employed to account for nonlinear creep deformation characteristics. By considering the time-dependent effects, the model can be applied to both instantaneous loading and creep conditions. The general algorithm format is derived in detail, and an explicit integration algorithm is utilized to update the time-dependent damage evolution. Finally, the proposed model is validated by comparing its predictions with the short and long-term mechanical responses of Beishan granite and Rumei dacite. This comprehensive constitutive model improves our understanding of continuum damage mechanics and provides a scientific basis for analyzing and evaluating the long-term safety and stability of deep hard rock engineering projects.

show abstract

Deformation and Acoustic Emission Characteristics of Cracked Granite during Creep

Cited by 3 publications

References 19 publications

Analysis of Acoustic Emission Characteristics and Failure Mode of Deep Surrounding Rock of Sanshandao Gold Mine

Analysis of Acoustic Emission Characteristics and Failure Mode of Deep Surrounding Rock of Sanshandao Gold Mine

Experimental Research on Coal and Gas Delay Outburst and AE Characteristics under Conditions of Geostress and Gas Pressure Disturbance

A novel time-dependent damage constitutive model for hard rock materials

Contact Info

Product

Resources

About