Deformability of polyvinyl chloride in creep conditions

Pichugina, S.V.; Lebedev, V.P.; Samarskaya, N.I.; Batuyeva, L.I.; Razinskaya, I.N.; Slutsker, A. I.

doi:10.1016/0032-3950(82)90396-3

Cited by 1 publication

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Numerous electrical properties are affected by this, but it has been studied only to a very limited extent [100]. Several studies on creep of PVC have been published [101,102] but none directly address electric failures. Subjecting a cord or cable to a sizable, sustained pinching force is known to be a cause of fires and the general nature of failure due to creep has briefly been reviewed [41].…”

Section: Creep Of Insulationmentioning

confidence: 99%

Mechanisms and modes for ignition of low-voltage, PVC-insulated electrotechnical products

Babrauskas

2006

Fire Mater.

View full text Add to dashboard Cite

SUMMARYPVC is the most common insulation material used for wiring in low-voltage (LV) service. 'Low-voltage', in the context of this paper, is taken to be 120-240 VAC. The electrotechnical products considered include insulated wires, cables and cords, and also appurtenant termination devices, e.g. male plugs or female taps. Well-known factors leading to the ignition of PVC-insulated wiring and related products include: (a) manufacturing defects; (b) grossly excessive current; (c) over-insulation, sometimes augmented by overcurrent; (d) localized heating due to strand breakage; (e) localized heating due to mechanical strand severing by staples or nails; and (f) localized heating due to failed terminations. Other failure modes are known but have received only limited study. These include (i) excessive force and creep; (ii) chemical interaction effects; and (iii) breakdown under voltage surge conditions. Additional research is needed in these areas. The proximate cause of ignition involved with many of the above mechanisms is arc tracking (arcing across a carbonized path). In turn, it is shown that PVC is especially susceptible to becoming charred, it requiring only approximately 1608C for the material to become semiconducting during shortterm exposure (around 10 h), while longer-term exposure (around 1 month) may cause failures at temperatures as low as 1108C. Some limited data exist which suggest that standard UL and IEC temperature classifications are unduly optimistic, as applied to PVC. Fire can originate if wiring or equipment cannot withstand a powerline surge. Mains-connected electrical appliances need to be designed to resist 6000 V surge voltages, even though this is not mandated in most of the current UL and IEC standards. Data are presented showing that the IEC 60112 wet-tracking test gives especially misleading results for PVC and should be improved or abrogated.

show abstract

Section: Creep Of Insulationmentioning

confidence: 99%

Mechanisms and modes for ignition of low-voltage, PVC-insulated electrotechnical products

Babrauskas

2006

Fire Mater.

View full text Add to dashboard Cite

show abstract

Deformability of polyvinyl chloride in creep conditions

Cited by 1 publication

References 3 publications

Mechanisms and modes for ignition of low-voltage, PVC-insulated electrotechnical products

Mechanisms and modes for ignition of low-voltage, PVC-insulated electrotechnical products

Contact Info

Product

Resources

About