Dante soft x-ray power diagnostic for National Ignition Facility

Dewald, E. L.; Campbell, Kelly; Turner, R. E.; Holder, J. P.; Landen, O. L.; Glenzer, S. H.; Kauffman, R. L.; Suter, L. J.; Landon, Mark; Rhodes, M.; Lee, D.

doi:10.1063/1.1788872

Cited by 218 publications

(62 citation statements)

References 5 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Direct hard x-ray imaging of the capsule highenergy bremsstrahlung emission [25] has measured 500 J of electrons with energies > 170 keV that have the potential to generate fuel pre-heat; this value is about a factor of 2 below current estimated upper limits acceptable for ignition [1]. The hohlraum radiation temperature produced in these experiments is inferred from measurements of the x-ray power, P , in the energy range of 0 < E X−ray < 20 keV out of the LEH with the absolutely calibrated broadband x-ray spectrometer Dante [5,28,53,54]. The measured radiant intensity provides the temperature via dP/dΩ = A LEH (t)φ(t) cos θσT 4 RAD /π.…”

Section: Laser and Hohlraum Drivementioning

confidence: 99%

Cryogenic thermonuclear fuel implosions on the National Ignition Facility

et al. 2012

Self Cite

View full text Add to dashboard Cite

The first inertial confinement fusion implosion experiments with equimolar deuterium-tritium thermonuclear fuel have been performed on the National Ignition Facility. These experiments use 0.17 mg of fuel with the potential for ignition and significant fusion yield conditions. The thermonuclear fuel has been fielded as a cryogenic layer on the inside of a spherical plastic capsule that is mounted in the center of a cylindrical gold hohlraum. Heating the hohlraum with 192 laser beams for a total laser energy of 1.6 mega joules produces a soft x-ray field with 300 eV temperature. The ablation pressure produced by the radiation field compresses the initially 2.2-mm diameter capsule by a factor of 30 to a spherical dense fuel shell that surrounds a central hot-spot plasma of 50 µm diameter. While an extensive set of x-ray and neutron diagnostics has been applied to characterize hot spot formation from the x-ray emission and 14.1 MeV deuterium-tritium primary fusion neutrons, thermonuclear fuel assembly is studied by measuring the down-scattered neutrons with energies in the range of 10 to 12 MeV. X-ray and neutron imaging of the compressed core and fuel indicate a fuel thickness of (14 ± 3) µm, which combined with magnetic recoil spectrometer measurements of the fuel areal density of (1 ± 0.09) g cm −2 result in fuel densities approaching 600 g cm −3 . The fuel surrounds a hot-spot plasma with average ion temperatures of (3.5 ± 0.1) keV that is measured with neutron time of flight spectra. Absolute neutron yields of (7.5 ± 0.1) × 10 14 have been recorded from the magnetic recoil spectrometer and nuclear activation diagnostics while gamma ray measurements provide the duration of nuclear activity of (170 ± 30) ps. These indirect-drive implosions result in the highest areal densities and neutron yields achieved on laser facilities to date. This achievement is the result of the first hohlraum and capsule tuning experiments where the stagnation pressures have been systematically increased by more than a factor of 10 by fielding low-entropy implosions through the control of radiation symmetry, small hot electron production, and proper shock timing. The stagnation pressure is above 100 Gbar resulting in high Lawson confinement parameters of P τ 10 atm s. Comparisons with radiation-hydrodynamic simulations indicate that the pressure is within a factor of three required for reaching ignition and high yield. This will be the focus of future higher-velocity implosions that will employ additional optimizations of hohlraum, capsule and laser pulse shape conditions.

show abstract

Section: Laser and Hohlraum Drivementioning

confidence: 99%

Cryogenic thermonuclear fuel implosions on the National Ignition Facility

et al. 2012

Self Cite

View full text Add to dashboard Cite

show abstract

“…1d. This is captured by the Dante diagnostic [15,16], which measures the x-ray spectrum from 0 to 20 keV emitted through the LEH.…”

Section: Inferring Srs On the 235 • Conementioning

confidence: 99%

Three-wavelength scheme to optimize hohlraum coupling on the National Ignition Facility

Michel¹,

Divol²,

Town³

et al. 2011

Phys. Rev. E

Self Cite

View full text Add to dashboard Cite

By using three tunable wavelengths on different cones of laser beams on the National Ignition Facility, numerical simulations show that the energy transfer between beams can be tuned to redistribute the energy within the cones of beams most prone to backscatter instabilities. These radiative hydrodynamics and laser-plasma interaction simulations have been tested against large scale hohlraum experiments with two tunable wavelengths, and reproduce the hohlraum energetics and symmetry. Using a third wavelength provides a greater level of control of the laser energy distribution and coupling in the hohlraum, and could significantly reduce stimulated Raman scattering losses and increase the hohlraum radiation drive while maintaining a good implosion symmetry.

show abstract

“…For these reasons, in the present work, the soft x-ray conversion efficiency was measured in a convergent direct drive-like set-up [11], on spheres made of Au, cocktail and U uniformly heated by laser beams at the Omega Laser Facility [12]. The absolute soft x-ray flux in the 100 eV to 5 keV spectral range was measured temporally resolved with the Dante broadband spectrometer [14]. Dante is a collection of absolutely calibrated vacuum x-ray diodes (XRD) filtered individually with edge filters and mirrors for different soft x-ray energy ranges up to 12 keV.…”

Section: Introductionmentioning

confidence: 99%

X-ray conversion efficiency of high-Z hohlraum wall materials for indirect drive ignition

et al. 2008

Self Cite

View full text Add to dashboard Cite

We measure the conversion efficiency of 351 nm laser light to soft x-rays (0.1-5 keV) for Au, U and high Z mixtures "cocktails" used for hohlraum wall materials in indirect drive ICF. We use spherical targets in a direct drive geometry, flattop laser pulses and laser smoothing with phase plates to achieve constant and uniform laser intensities of 10 14 and 10 15 W/cm 2 over the target surface that are relevant for the future ignition experiments on NIF. The absolute time and spectrally-resolved radiation flux is measured with a multichannel soft x-ray power diagnostic. The conversion efficiency is then calculated by dividing the measured x-ray power by the incident laser power from which the measured laser backscattering losses is subtracted. After ~0.5 ns, the time resolved x-ray conversion efficiency reaches a slowly increasing plateau of 95% at 10 14 W/cm 2 laser intensity and of 80% at 10 15 W/cm 2 . The M-band flux (2-5 keV) is negligible at 10 14 W/cm 2 reaching ~1% of the total x-ray flux for all target materials. In contrast, the Mband flux is significant and depends on the target material at 10 15 W/cm 2 laser intensity, reaching values between 10% of the total flux for U and 27% for Au. Our LASNEX simulations show good agreement in conversion efficiency and radiated spectra with data when using XSN atomic physics model and a flux limiter of 0.15, but they underestimate the generated M-band flux. I IntroductionIn indirect drive inertial confinement fusion (ICF) experiments, intense laser or charged particle beams heat the interior of high-Z cylindrical cavities called hohlraums to efficiently generate soft x-rays. The role of the soft x-rays is to uniformly produce an ablation drive that compresses the DT filled capsule placed inside the hohlraum, driving it to ignition and burn [1]. Due to the relaxed requirements on laser-beam uniformity and reduced sensitivity to hydrodynamic instabilities the indirect drive scenario is the main approach for future ignition experiments at the National Ignition Facility (NIF) [2,3,4]. In such a hohlraum containing a capsule and heated by laser beams the power balance is given by [5,6]:η CE (P laser -P backscatter ) = P walls +P LEH + P capsule =σT R 4 [(1-α)A wall +A LEH +f capsule A capsule ] (1) where η CE is the laser conversion efficiency into soft x-rays (<2 keV), P laser is the incident laser power, P backscatter is the backscattered light by parametric laser-plasma instabilities, P capsule is the radiation absorbed by the capsule, P LEH is the radiation escaping through the hohlraum laser entrance holes (LEH) and P walls is the radiation loss in the hohlraum walls.Furthermore, σ is the Stefan-Boltzmann constant, T R is the hohlraum radiation temperature (≤300 eV), α is the x-ray albedo of the hohlraum wall [7], defined as the ratio between the re-emitted and incident soft x-ray flux at the hohlraum wall, A wall and A LEH are the areas of the hohlraum wall and LEH's, f capsule is the fraction of incident x-ray flux that is absorbed by the capsule and A ...

show abstract

Dante soft x-ray power diagnostic for National Ignition Facility

Cited by 218 publications

References 5 publications

Cryogenic thermonuclear fuel implosions on the National Ignition Facility

Cryogenic thermonuclear fuel implosions on the National Ignition Facility

Three-wavelength scheme to optimize hohlraum coupling on the National Ignition Facility

X-ray conversion efficiency of high-Z hohlraum wall materials for indirect drive ignition

Contact Info

Product

Resources

About