DAid pressure socks system: Performance evaluation

Eizentals, Peteris; Katashev, Alexei; Oks, Alexander; Pavare, Zane

doi:10.1016/j.gaitpost.2021.01.007

Cited by 2 publications

(1 citation statement)

References 21 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The research used dAid smart socks and data acquisition modules, developed at Riga Technical University [29,35]. The socks (Fig.…”

Section: Smart Socks and Data Acquisition Modulementioning

confidence: 99%

Estimation of the knee joint load using plantar pressure data measured by smart socks: A feasibility study

Daugulis,

Kataševs,

Okss

2023

THC

View full text Add to dashboard Cite

BACKGROUND: Unsupervised sports activities could cause traumas, about 70% of them are those of the low extremities. To avoid traumas, the athlete should be aware of dangerous forces acting within low extremity joints. Research in gait analysis indicated that plantar pressure alteration rate correlates with the gait pace. Thus, the changes in plantar pressure should correlate with the accelerations of extremities, and with the forces, acting in the joints. Smart socks provide a budget solution for the measurement of plantar pressure. OBJECTIVE: To estimate the correlation between the plantar pressure, measured using smart socks, and forces, acting in the joints of the lower extremities. METHODS: The research is case study based. The volunteer performed a set of squats. The arbitrary plantar pressure-related data were obtained using originally developed smart socks with embedded knitted pressure sensors. Simultaneously, the lower extremity motion data were recorded using two inertial measurement units, attached to the tight and the ankle, from which the forces acted in the knee joint were estimated. The simplest possible model of knee joint mechanics was used to estimate force. RESULTS: The estimates of the plantar pressure and knee joint forces demonstrate a strong correlation (r= 0.75, P< 0.001). The established linear regression equation enables the calculation of the knee joint force with an uncertainty of 22% using the plantar pressure estimate. The accuracy of the classification of the joint force as excessive, i.e., being more than 90% of the maximal force, was 82%. CONCLUSION: The results demonstrate the feasibility of the smart socks for the estimation of the forces in the knee joints. Smart socks therefore could be used to develop excessive joint force alert devices, that could replace less convenient inertial sensors.

show abstract

“…The research used dAid smart socks and data acquisition modules, developed at Riga Technical University [29,35]. The socks (Fig.…”

Section: Smart Socks and Data Acquisition Modulementioning

confidence: 99%