Crystal structures of bis[4-(dimethylamino)pyridinium] tetrakis(thiocyanato-κ<i>N</i>)manganate(II) and tris[4-(dimethylamino)pyridinium] pentakis(thiocyanato-κ<i>N</i>)manganate(II)

Neumann, Tristan; Jeß, Inke; Näther, Christian

doi:10.1107/s2056989017017510

Cited by 1 publication

(1 citation statement)

References 24 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…It is obvious that, until now, there has been no single crystal data available for imidazolium-based systems, which contain pseudohalides as ligands in the complex anion [Mn II (NCX) 4 ] 2− ( X = O, S). There are only few reports on crystal structures of [Mn II (NCS) 4 ] 2− containing systems [50,51,52,53], and only one single report on the crystal structure of a [Mn II (NCO) 4 ] 2− containing system, [Ni(bpy) 3 ][Mn(NCO) 4 ]·H 2 O (bpy = 2,2′-bipyridine) [54], respectively.…”

Section: Introductionmentioning

confidence: 99%

Low-Melting Manganese(II)-Based Ionic Liquids: Syntheses, Structures, Properties and Influence of Trace Impurities

et al. 2019

View full text Add to dashboard Cite

The synthesis of more than 10 new magnetic ionic liquids with [MnX4]2− anions, X = Cl, NCS, NCO, is presented. Detailed structural information through single-crystal X-ray diffraction is given for (DMDIm)[Mn(NCS)4], (BnEt3N)2[Mn(NCS)4], and {(Ph3P)2N}2[Mn(NCO4)]·0.6H2O, respectively. All compounds consist of discrete anions and cations with tetrahedrally coordinated Mn(II) atoms. They show paramagnetic behavior as expected for spin-only systems. Melting points are found for several systems below 100 °C classifying them as ionic liquids. Thermal properties are investigated using differential scanning calorimetry (DSC) measurements. The physicochemical properties of density, dynamic viscosity, electrolytic conductivity, and surface tension were measured temperature-dependent of selected samples. These properties are discussed in comparison to similar Co containing systems. An increasing amount of bromide impurity is found to affect the surface tension only up to 3.3%.

show abstract