Creep Properties of 9Cr and 14Cr ODS Tubes Tested by Inner Gas Pressure

Sornin, Denis; Ehrnstén, Ulla; Mozzani, N.; Rantala, Juha; Walter, M.; Hobt, A.; Aktaa, Jarir; Oñorbe, E.; Hernández‐Mayoral, M.; Ulbricht, A.; Gicquel, S.; Frank, L.; Carlan, Y. de

doi:10.1007/s11661-021-06327-0

Cited by 1 publication

(1 citation statement)

References 31 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…In service, these welds will be submitted to elevated temperatures, high irradiation doses and a constant increase in the internal pressure induced by fission gases [31,32]. An adequate weld shape is required to insure the improved mechanical strength of the welded assembly.…”

Section: Optimization Of the Joint Plane Shapementioning

confidence: 99%

Optimization of the Pressure Resistance Welding Process for Nuclear Fuel Cladding Coupling Experimental and Numerical Approaches

Mabrouki

Gonçalves

Pascal

et al. 2023

Metals

View full text Add to dashboard Cite

An approach coupling experimental tests and numerical simulation of the pressure resistance welding (PRW) process is proposed for optimizing fuel cladding welds for the new generation of nuclear reactors. Several experimental welds were prepared by varying the dissipated energy, which accounts for the effect of electric current and welding time applied during the PRW process. A working zone, a function of both applied dissipated weld energy and plug-displacement, was then identified on the basis of the microscopy observations of the weld defects. In addition, the numerical approach, based on a 2D axisymmetric multi-physics finite element model, was developed to simulate the PRW process in a plug-tube configuration. The proposed model accounted for interactions between the electrical, thermal and mechanical phenomena and the electro-thermo-mechanical contact between the pieces and electrodes. Numerical simulations were first validated by comparison to experimental measurements, notably by comparing the plug-displacement and the size and position of the heat-affected zone (HAZ). They were then used to assess the effect of the applied parameters on the maximum temperature and cumulated plastic strain reached during welding and the effect of the welding force on the quality of the weld. According to the numerical computations, the maximum temperature reached in the weld remains well below the melting temperature. Changing the welding force implies also modifying the applied energy in order to maintain the quality of the welds. Applied to different plug and clad geometries, the proposed model was shown to be useful for optimizing the joint plane for such a welding configuration.

show abstract

Section: Optimization Of the Joint Plane Shapementioning

confidence: 99%