Cost-effective and rapid prototyping of PMMA microfluidic device via polymer-assisted bonding

Sözmen, Alper Baran; Yıldız, Ahu Arslan

doi:10.1007/s10404-021-02466-3

Cited by 6 publications

(1 citation statement)

References 34 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…Polymethyl methacrylate (PMMA) which is an inexpensive thermoplastic material offers several advantages such as high optical transparency, chemical resistance, inertness, cost-effectiveness, and biocompatibility [37,38]. Unlike poly dimethyl siloxane (PDMS) which is an elastomeric material, PMMA provides better mechanical properties and is more robust [39,40]. The rigidity, durability, and high resistance to deformation are the significant features that facilitate PMMA molds to be reused numerous times for any replica transfer methods [36].…”

Section: Introductionmentioning

confidence: 99%

Design and fabrication of microfluidic devices: a cost-effective approach for high throughput production

Thomas,

Agrawal

2023

J. Micromech. Microeng.

View full text Add to dashboard Cite

Microdevices have been recognized as a potential platform for performing numerous biomedical analysis and diagnostic applications. However, promising and viable techniques for a cost-effective and high throughput production of microfluidic devices still remain as a challenge. This paper addresses this problem with an alternative solution for the fabrication of microfluidic devices in a simple and efficient manner. We utilized laser-assisted engraving technique to fabricate a master mold on an acrylic sheet of different thicknesses from 4 to 20mm. Low cost indigenously developed CO2 (10.6μm wavelength) laser engraving device was used for the experiments. The effect of various laser parameters such as power and speed of operation on the height of engraved structures was studied in detail. Optimal engraving results were obtained with a laser speed of 200–250mm s−1 with a spacing interval of 0.002mm at a laser power of 10–12W. Master mold of microdevice with a channel width of 100μm were produced using this technique. The replica transfer was performed by a simple imprinting method using a benchtop universal testing machine that can provide a maximum compressive load upto 1kN. The replicas were successfully generated on various thin film substrates including polymers, plastics, Whatman filter paper, teflon, vinyl sheets, copper, and aluminum sheets. The effect of load applied on the depth of the microfluidic channel was studied for the substrates such as teflon and Whatman filter paper. A load of 1kN can generate a depth of a few hundred micrometers on various substrates mentioned above. The replicas were also transferred to thermoformable PETG (polyethylene terephthalate glycol) sheets under load with an elevated temperature. The channel-imprinted PETG substrates were later sandwiched between two acrylic sheets with adhesive-coated polymer sheets and screws at the corners. Soft lithographic techniques were also performed to replicate the channel on a poly dimethyl siloxane substrate which was later bonded to a glass plate using an oxygen plasma cleaner device. Fluidic flow testing was conducted by pumping dye-mixed deionized (DI) water through the channels using a syringe pump and connecting tubes at a constant flow rate of 5ml min−1. The outcomes of this study provide an alternative solution for a simple and low-cost method for microdevice fabrication at a large scale.

show abstract