Correlations between Thermal Loads during Grind-Hardening and Material Modifications Using the Concept of Process Signatures

Abstract

During the process of grind-hardening, the dissipated heat from the process is utilized for a surface layer hardening of machined components made of steel. A martensitic phase transformation occurs within the affected subsurface regions and compressive residual stresses are induced. However, the layout of a grind-hardening process for given hardness results (material modification) is very difficult. Thus, a series of extensive experimental tests is required. To reduce this experimental effort, the newly developed concept of Process Signatures is used to describe the material modifications based on the thermal load appearing during the grind-hardening process. Based on an analytical calculation of the temperature fields during the grind-hardening process (surface-and external-cylindrical-grind-hardening), the internal thermal load was characterized by the maximum contact zone temperature and the maximum temperature gradient at the surface and was correlated with the process quantities (heat flux to the workpiece and the contact time).Metallographic investigations were used to analyze the surface hardening depth and the hardness change at the surface, which were correlated with the quantities describing the internal material loads. The results show that the surface hardening depth was mainly governed by the maximum contact zone temperature and the maximum temperature gradient at the surface, whereas the hardness change at the surface was influenced additionally by the quenching time.