Correction of frequency characteristics of seismic sensors and noise of corresponding measuring channels

Besedina, A. N.; Kabychenko, N. V.; Kocharyan, G. G.; Павлов, Д. В.

doi:10.3103/s0747923912010021

Cited by 6 publications

(1 citation statement)

References 3 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The traditional way to increase the damping ratio is to introduce negative resistance. The damping of the sensor oscillation system is mainly determined by the impedance in the coil circuit; the smaller the internal resistance of the coil circuit is, the greater the damping [ 40 , 41 ]. The circuit shown in Figure 2 a uses an op amp to convert the positive impedance to negative, thereby introducing a negative resistance.…”

Section: Series Circuit Correction Methodsmentioning

confidence: 99%

An Effective Method for Improving Low-Frequency Response of Geophone

et al. 2023

Sensors

View full text Add to dashboard Cite

The natural frequency of traditional velocity sensors such as moving coil geophones limits their measurable low-frequency range, and the damping ratio affects the flatness of the sensor in the amplitude and frequency curves, resulting in variations in sensitivity over the available frequency range. In this paper, the structure and working principle of the geophone are analyzed and its dynamics are modeled. After synthesizing the negative resistance method and zero-pole compensation, two commonly adopted low-frequency extension methods, a method for improving low-frequency response, which is a series filter and a subtraction circuit to increase the damping ratio, is proposed. Applying this method to improve the low-frequency response of the JF-20DX geophone, which has a natural frequency of 10 Hz, results in a flat response to acceleration in the frequency range from 1 to 100 Hz. Both the PSpice simulation and actual measurement show a much lower noise level via the new method. Testing the vibration at 10 Hz, the new method has a 17.52 dB higher signal-to-noise ratio than the traditional zero-pole method. Both theoretical analysis and actual measurement results show that this method has a simple circuit structure, introduces less circuit noise, and has a low-frequency response improvement effect, which provides an approach for the low-frequency extension of moving coil geophones.

show abstract

Section: Series Circuit Correction Methodsmentioning

confidence: 99%