Control of serial microfluidic droplet size gradient by step-wise ramping of flow rates

Abstract

This paper describes a method to control and detect droplet size gradient by step-wise flow rate ramping of water-in-oil droplets in a microfluidic device. The droplets are generated in a cross channel device with two oil inlets and a water inlet. The droplet images are captured and analyzed in a time sequence in order to quantify the droplet generation frequency. It is demonstrated that by controlling the ramping of the oil flow rates it is possible to manipulate the ramping of droplet sizes. Increasing or decreasing of droplet sizes is achieved for a step-wise triangular ramping profile of the oil flow rate. The dynamic behavior of droplets due to the step-wise flow pulses is investigated. Uniform linear size ramping of water-in-oil droplets from 73 to 83 lm in diameter is generated with an oil flow ramping range from 1 to 11 lL/min in a minimum of five steps while water flow rate is held constant at 2 lL/min.

Preparation of monodisperse PEG hydrogel microparticles using a microfluidic flow-focusing device

“…The droplet size is determined by the flow rates of the two phases and by the flow rate ratio as proposed by Collins et al [17] and Ward et al [18]. And the viscosities of the two phases could influence on the droplet formation [19,20].…”

Numerical study on the effect of viscoelasticity on drop deformation in simple shear and 5:1:5 planar contraction/expansion microchannel

“…Microfluidic channels have been extensively used due to their inherent high-throughput way of operation [4,5]. In microparticle fabrication, one important issue is to control the shape of the microparticles, which is typically realized through two-phase fluid systems [5][6][7] or continuous flow lithography [3,4,8]. Thus, it is essential to understand drop dynamics in two-phase systems to generate a targeted shape.…”

Surface quality of aluminium extrusion products

“…Finally, the stream of the dispersed phase becomes narrow and breaks into droplets. The droplet size is determined by the flow rates of the two phases and by the flow rate ratio, [89][90] in addition to the channel geometries 91 and the viscosities of the two phases. [92][93] This multitude of influential parameters in principle offers a lot of control over drop formation, but it is also true that in the absence of quantitatively predicting models, each new combination of geometry, speeds and viscosities may need to be explored and tuned, in order to let the chip meet the demands (i.e.…”