Confecção de um perfurador de lamínulas de vidro por corrosão ácida

Silva, Heron Dominguez Torres da; Lago, Claudimir Lúcio do

doi:10.1590/s0100-40422003000200022

Cited by 1 publication

(2 citation statements)

References 14 publications

(14 reference statements)

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The size of the cover glass depends on the layout of the device. The channels can be accessed at the edge of the cover glass or by drilling a hole through it [15]. Solution reservoirs were formed by gluing 5 mm long and 8 mm OD tubes made of poly(vinyl chloride) (PVC) at the channel entrances with bicomponent epoxy glue, as shown in Fig.…”

Section: Fabrication Processmentioning

confidence: 99%

See 1 more Smart Citation

Microfluidic devices obtained by thermal toner transferring on glass substrate

et al. 2004

View full text Add to dashboard Cite

A new process for the manufacture of microfluidic devices based on deposition of laser-printing toner on glass substrates is described. It is an alternative method to the toner on polyester film (toner-polyester) one, previously introduced. Commercial laser printers cannot print directly on glass, thus the toner must first be printed on a special paper and then transferred by heating under pressure to the glass surface. Although this procedure is more complex than the toner-polyester one, it can be repeated several times, yielding multiple toner layers. Even without special alignment equipment, up to four layers could be satisfactorily piled up. Characterization tests revealed that the toner-glass devices have similar behavior as toner-polyester ones regarding the toner layer porosity. The main advantages of the toner-glass technology are improved mechanical stability, possibility of multiple toner layers, augmented electroosmotic flow (EOF), and improved heat transfer. On the other hand, toner adhesion to glass is weaker than to polyester, which limits the device lifetime and usable liquid media. The measured EOF mobility (3.5 x 10(-4) cm2.V(-1).s(-1) for pH 7) suggests that it is mainly determined by the glass surface, being little influenced by the toner walls. Microchip electrophoresis with contactless conductivity detection and photometric detection were implemented using toner-glass devices.

show abstract

Section: Fabrication Processmentioning

confidence: 99%

“…The thermal conductivity of the glass is greater than the one for PET: 0. 15 [21]. The cover thickness has the same magnitude for both devices (100 mm for PET film and 150 mm for glass), but the substrate thickness is quite different.…”

Section: Dimensional Electrical and Chemical Characterizationmentioning

confidence: 99%