Compressive and tensile mechanical properties of the porcine nasal septum

Abstract

The expanding nasal septal cartilage is believed to create a force that powers midfacial growth. In addition, the nasal septum is postulated to act as a mechanical strut that prevents the structural collapse of the face under masticatory loads. Both roles imply that the septum is subject to complex biomechanical loads during growth and mastication. The purpose of this study was to measure the mechanical properties of the nasal septum to determine (1) whether the cartilage is mechanically capable of playing an active role in midfacial growth and in maintaining facial structural integrity and (2) if regional variation in mechanical properties is present that could support any of the postulated loading regimens. Porcine septal samples were loaded along the horizontal or vertical axes in compression and tension, using different loading rates that approximate the in vivo situation. Samples were loaded in random order to predefined strain points (2–10%) and strain was held for 30 or 120 seconds while relaxation stress was measured. Subsequently, samples were loaded until failure. Stiffness, relaxation stress and ultimate stress and strain were recorded. Results showed that the septum was stiffer, stronger and displayed a greater drop in relaxation stress in compression compared to tension. Under compression, the septum displayed non-linear behavior with greater stiffness and stress relaxation under faster loading rates and higher strain levels. Under tension, stiffness was not affected by strain level. Although regional variation was present, it did not strongly support any of the suggested loading patterns. Overall, results suggest that the septum might be mechanically capable of playing an active role in midfacial growth as evidenced by increased compressive residual stress with decreased loading rates. However, the low stiffness of the septum compared to surrounding bone does not support a strut role. The relatively low stiffness combined with high stress relaxation under fast loading rates suggests that the nasal septum is a stress dampener, helping to absorb and dissipate loads generated during mastication.

The biomechanical role of the chondrocranium and sutures in a lizard cranium

“…Thus, a large range of values can be found in the literature for Young's modulus (0.5–564 MPa) of cartilage (e.g. [ 18 , 73 , 75 , 76 , 78 – 80 ]). Many values are derived from measurements under slow loading of unmineralized hyaline cartilage, but reported Young's modulus values are typically below 10 MPa (e.g.…”

Yield Strength Testing in Human Cadaver Nasal Septal Cartilage and L-Strut Constructs

“…To our knowledge, YS has never been tested in human nasal septal cartilage. 10 However, we believe that it is an important aspect of the nasal mechanics to understand. Most septal literature focuses on tensile strength, which is determined using the elastic modulus by Young, an intrinsic property of a material, although tensile strength does not provide any information on the limits of stress that the CNS can endure.…”

Thermo-Mechanical Behaviour of Human Nasal Cartilage

“…This behaviour can be correlated to the hydration degree of cartilages, which was observed to be frequency independent. It seems that the cartilage viscoelastic properties in unconfined compression are only triggered by the fluid mobility and structural interactions between reinforcing collagen and surrounding matrix gel [8,48,[67][68][69][70].…”

“…Tendons and ligaments, blood vessels, aortic valves, intervertebral discs, skin, and cartilage have been widely described in the literature from very early [1][2][3][4][5][6][7]. Cartilage is a resilient and viscoelastic tissue composed of specialized cells (chondrocytes) that is found in nose, ears, intervertebral discs, larynx, trachea, and thorax, as well as covering and protecting bones at the articular joints [8,9]. Due to its natural anisotropic organization, cartilage behaves differently in a variety of tensile and compressive modes [9][10][11][12].…”