Composed planar Hall effect sensors with dual-mode operation

et al. 2017

In this paper, the flexible magnetoelectric (ME) transducer consisting of FeSiB (Metglas)/poly(vinylidene fluoride) (PVDF) is presented, whose ME coupling characteristics and ME sensing performance under different bend status have been investigated. It is found that an appropriate size of transducers is propitious to the ME coupling characteristics due to the demagnetization effect. In addition, with increase the bending angle (θ) of transducers from 0° to 50°, the magnetoelectric voltage coefficient (MEVC) shows a reduction from 240.42 to 26.44 V/cm·Oe and 13.1 to 2.11 V/cm·Oe, at the resonance and low-frequency (1 kHz), respectively. Meanwhile, the induced ME voltage have an excellent linear relationship to ac magnetic field. An ultrahigh magnetic field sensitivity of 1.22 V/Oe and 0.11 V/Oe have been found under θ = 0° and 50°, respectively, which are positively comparable to the highest reported in the most recent polymer-based ME transducers. Moreover, the transducers can maintain the MEVC stable after an additionally bending cycles up to 1000 times, indicating the full flexibility and high stability of the mentioned transducers. Obviously, it demonstrates that the proposed FeSiB/PVDF transducers have great potential of being applied to wearable devices.

Section: Introductionmentioning

confidence: 99%

Flexible magnetoelectric transducer with high magnetic field sensitivity based on Metglas/poly(vinylidene fluoride) heterostructures

Long

et al. 2017

A high-sensitivity zero-biased magnetoelectric sensor using five-phase laminate composites based on FeCoV nanocrystalline soft magnetic alloy

Gao

et al. 2017

This paper present a high-sensitivity zero-biased ME sensor consists of FeCoV/Terfenol-D/Pb(Zr1-x,Tix)O3(PZT)/Terfenol-D/FeCoV (FMPMF), whose magnetoelectric (ME) coupling characteristics and ME sensing performance have been investigated. Compared to traditional Terfenol-D/PZT/Terfenol-D (MPM) sensor, the zero-biased ME coupling characteristics of FMPMF sensor were significantly improved. Meanwhile, the induced zero-biased ME voltage of FMPMF sensor shows an excellent linear relationship to ac magnetic field both at the low frequency (1kHz) and the resonant frequency (115.14 kHz). The measured sensitivity at resonance is 1.95 V/Oe and the output resolution is approximately 2.43×10-8T. The proposed FMPMF sensors still have very good performance in the current sensing. The measured results shows an average sensitivity of 1.14 mV/A with highly linear behavior in the current range 1 A to 10 A at 50 Hz. Remarkably, it indicates that the proposed zero-biased miniature ME sensor give the prospect of being able to applied to the field of highly sensitive current sensing for the electricity monitoring in electric power grid.

Multi-directional electromagnetic vibration energy harvester using circular Halbach array

Liu

et al. 2017

In this paper, a multi-directional electromagnetic vibration energy harvester (EVEH) using the circular Halbach array (HA) is presented based on the Faraday’s law of electromagnetic induction. The circular HA is a specific arrangement of permanent magnets which could concentrate the magnetic field inside the circular array by a certain rule, while reduce the magnetic field outside the circular array to almost zero at the same time. The HA could break through the limitation of the related published vibration energy harvesters that could work in only one single direction. Thus, it could optimize the collecting efficiency. The experimental results show that the presented harvester could generate considerable electric output power in all vibrating directions. An optimal output power is 9.32 mW at a resonant frequency of 15.40 Hz with an acceleration of 0.5 g (with g=9.8 m/s2) across a 700-turn coil in the vibrating direction of 90°, which is 1.53 times than the minimum optimal one in the direction of 45°. The EVEH using the circular HA could work in all directions and generate considerable electric output power, which validates the feasibility of the EVEH that works in all directions and is beneficial for improving the practical application.