Complete and versatile remote controller for PV systems

Cano, Juan; Herrera, Reyes S.; Martín, Aránzazu D.; Vázquez, Jesús R.

doi:10.1016/j.ijepes.2022.108324

Cited by 2 publications

(1 citation statement)

References 26 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…The PInv is controlled to supply the AC loads and to inject the resting energy to the PS, [6]- [7]. In the gridconnected mode, the PInv could be also used as a shunt active power filter and an adequate current control would allow the improvement of the power quality in the PCC, [8]- [11]. When the power system breaks down, the PInv control system will change to operate as a voltage source to only supply the SG AC loads.…”

Section: Introductionmentioning

confidence: 99%

Inverter Control Design for the optimal management of electrical Microgrids

Vázquez,

Magro,

Herrera

et al. 2023

RE&PQJ

View full text Add to dashboard Cite

Nowadays, the promotion of renewable energy sources is a necessity. Technically, the increase of the renewable penetration in the power system (PS) is a challenge. One solution for this problem is the use of self-controlled microgrids (smartgrid, SG). In this work, the design of an algorithm to optimal manage the SG energy through the power inverter control in the SG is presented. In general, a SG consists of renewable energy sources, electrical loads and storage systems. In an isolated SG (no connected to the power system), a DC/AC (direct current / alternating current) converter (power inverter, PInv) is necessary to provide an alternating voltage to supply the loads. If the SG is connected to the PS, the PInv is used to inject the active power from the renewable energy sources.

show abstract

Section: Introductionmentioning

confidence: 99%