Comparison of Quantitative Feedback Theory Dependent Controller with Conventional PID and Sliding Mode Controllers on DC-DC Boost Converter for Microgrid Applications

Abstract

This paper is discussed towards the issue of variations happening in the voltage control method of DC-DC boost converter. Quantitative feedback theory (QFT) is adjusted to efficiently plan a robust PID regulator, which is acknowledged utilizing only output voltage of the plant sensed by voltage sensor. The benefits of the explained PID configuration by utilizing the QFT design (Tarakanath Kobaku et al. 25) is proved with the fact that it disposes the problem of extra work and ad-hoc tuning of PID gain utilizing the regular PID methods, current measurement isn't needed, it provides the design for case of nonminimum phase of boost converter even if there is restrictions on the bandwidth and disturbance factors are already included in the design of QFT based controller with the help of QFT bounds and thus disturbance effect is considered in the output of system. Various simulation results are taken in each case i.e. conventional PID controller and sliding mode controller. Here results are compared with the QFT based controller to verify the importance of this controller over other two controllers in terms of output response, reference tracking, line regulation and most importantly on the basis of cost effectiveness.

A Passivity-based Control Combined with Sliding Mode Control for a DC-DC Boost Power Converter

“…[45] presented the cascade system control design and stability analysis for a DC-DC boost converter with proportional integral and sliding mode controller and using singular perturbation theory. Some versions of sliding mode control approaches were presented in [48]- [54]. [53] presented an implementation of sliding mode voltage control controlled buck-boost converter for solar photovoltaic system.…”

Study of Fractional Order PI DC-DC Converter Based on Dual Closed-loop Control

“…Introduction DC-DC converters, which are the most applied circuit among the four major converter circuits in power electronics, have been widely used in new energy photovoltaic power generation, electric vehicle drive control, and switching power supplies [1] . The DC-DC converter is regarded as a power electronic nonlinear control system, to improve the static characteristics and dynamic indicators of the system so that the system has a good response speed and anti-interference ability, and the control policy has become one of the hot spots of research [2] . DC-DC converter commonly used voltage single-loop control, the structure is simple and easy to implement, but the response speed to the load jump is slow.…”