Comparison of Fractured-Horizontal-Well Performance in Tight Sand and Shale Reservoirs

Abstract

Summary This paper presents a discussion of fractured-horizontal-well performance in millidarcy permeability (conventional) and micro- to nanodarcy permeability (unconventional) reservoirs. It provides interpretations of the reasons to fracture horizontal wells in both types of formations. The objective of the paper is to highlight the special productivity features of unconventional shale reservoirs. By using a trilinear-flow model, it is shown that the drainage volume of a multiple-fractured horizontal well in a shale reservoir is limited to the inner reservoir between the fractures. Unlike conventional reservoirs, high reservoir permeability and high hydraulic-fracture conductivity may not warrant favorable productivity in shale reservoirs. An efficient way to improve the productivity of ultratight shale formations is to increase the density of natural fractures. High natural-fracture conductivities may not necessarily contribute to productivity either. Decreasing hydraulic-fracture spacing increases the productivity of the well, but the incremental production gain for each additional hydraulic fracture decreases. The trilinear-flow model presented in this work and the information derived from it should help the design and performance prediction of multiple-fractured horizontal wells in shale reservoirs.

Waterflooding Huff-n-puff in Tight Oil Cores Using Online Nuclear Magnetic Resonance

“…Because of the very low permeability and non-Darcy flow in tight oil reservoirs [5][6][7], a starting pressure gradient exists during waterflooding development, which leads to difficulties during injection, a rapid production decline [8][9][10], and insufficient formation energy challenges [11]. The development of tight oil reservoirs has mainly focused on the combination of horizontal wells and volume fracturing [12][13][14]. A large number of cracks occurs after reservoir volume fracturing [15][16][17][18], and waterflood development often results in a rapid outlet of water from the oil wells [19].…”

A mathematical model and semi-analytical solution for transient pressure of vertical fracture with varying conductivity in three crossflow rectangular layers

“…Over the past 30 years, thousands of papers have focused on the transient pressure analysis for a finite-conductivity fracture (Barros-Galvis et al, 2018;Chen et al, 2017;Cinco-Ley and Samaniego, 1981;Ozkan et al, 2011;Tian et al, 2017;Yuan et al, 2015aYuan et al, , 2015b.…”

Correction of source-rock permeability measurements owing to slip flow and Knudsen diffusion: a method and its evaluation

“…Source-rock matrix permeability is a key parameter to determine gas production rates from source-rock reservoirs (Ozkan et al 2011). Because gas flow in these reservoirs is associated with slip flow, Knudsen diffusion and other mechanisms, the rock matrix permeability, unlike that for conventional rock types, are not an intrinsic rock property, but depend on gas pressure and temperature (Civan 2010;Darabi et al 2012).…”