2014
DOI: 10.1007/s10762-014-0090-z
|View full text |Cite
|
Sign up to set email alerts
|

Compact and Sensitive Millimetre Wave Detectors Based on Low Barrier Schottky Diodes on Impedance Matched Planar Antennas

Help me understand this report

Search citation statements

Order By: Relevance

Paper Sections

Select...
3
1
1

Citation Types

0
16
0
1

Year Published

2016
2016
2022
2022

Publication Types

Select...
8

Relationship

0
8

Authors

Journals

citations
Cited by 23 publications
(17 citation statements)
references
References 21 publications
0
16
0
1
Order By: Relevance
“…Schottky diodes exploit the non-linearity of the IV characteristics to rectify an incoming RF signal. Narrow band designs reach noise equivalent powers (NEPs) of 0.4 pW/ √ Hz [2] in the upper microwave range (88 GHz) and a few pW/ √ Hz around 600 GHz [3]- [5]. An important design criterion for Schottky diodes is zero-bias operation in order to circumvent external noise contributions by a biasing circuit and to simplify the setup.…”
Section: Introductionmentioning
confidence: 99%
“…Schottky diodes exploit the non-linearity of the IV characteristics to rectify an incoming RF signal. Narrow band designs reach noise equivalent powers (NEPs) of 0.4 pW/ √ Hz [2] in the upper microwave range (88 GHz) and a few pW/ √ Hz around 600 GHz [3]- [5]. An important design criterion for Schottky diodes is zero-bias operation in order to circumvent external noise contributions by a biasing circuit and to simplify the setup.…”
Section: Introductionmentioning
confidence: 99%
“…Recently, detectors based on low barrier Schottky diodes have demonstrated an outstanding voltage responsivity, up to 1600 mV/mW at 87.8 GHz [5]. As reported in [4], these diodes can also be integrated with a mm wave rectenna and operated in a large-signal rectifying mode.…”
Section: Introductionmentioning
confidence: 91%
“…In the case of single-diode half-wave rectification, it is preferable to connect the diode in series [5]. Following this recommendation, the rectifier integrated with 2 × 2 patches array has been designed, fabricated, and tested.…”
Section: The Schottky Diode Rectenna Elementmentioning
confidence: 99%
“…2). [46]); II -R j = 2.9 kΩ, C j = 5 fF, R s = 45 Ω, Z A = 100 -100⋅j Ω (InGaAs SBD, parameters from [46]); III -R j = 700 kΩ, C j = 8 fF, R s = 10 Ω, Z A = 100 Ω (Si SBD, parameters from [45]), IV -R j = 2.4 kΩ, C j + C P = 7.1 fF, R s = 5.5 Ω, Z A = 24 + 231⋅j Ω (InGaAs SBD, parameters from [6], resonant impedance matching at 89 GHz). The values NEP opt for Si SBD from [45] were shown, as it is in the bias regime when R j = 600 Ω (instead of 700 kΩ in the zero-bias regime that was taken to calculate the curve III).…”
Section: Thz Rectifying Detector Parametersmentioning
confidence: 99%
“…Uncooled SBD single detectors, as compared to other ones (e.g., Golay cell, pyroelectric, bolometer, FET, superlattice detectors, etc. ), at the moment seem to be the most sensitive within the low-frequency THz range (ν<~300 GHz) where their NEP can reach NEP ~10 -11 …4⋅10 -13 W/Hz 1/2 (see [3][4][5][6], for Refs. see also [7]) in dependence on the radiation frequency range, antenna and detector impedances, antenna-detector matching, etc.…”
Section: Introductionmentioning
confidence: 99%