Cold Zone Exploration Using Position of Maximum Nusselt Number for Inclined Air Jet Cooling

Abstract

Inclined jet air cooling can be effectively used for cooling of electronics or other such applications. The non-confined air jet is impinged and experimentally investigated on the hot target surface to be cooled, which is placed horizontally. Analysis and evaluations are made by introduction of a jet on the leading edge and investigated for downhill side cooling to identify cold spots. The jet Reynolds number in the range of 2000 ≤ Re ≤ 20 000 is examined with a circular jet for inclination (Θ) of 15 < Θ < 75 degree. Also, the consequence of a jet to target distance (H) is explored in the range 0:5 ≤ H/D ≤ 6.8. For 45 degree jet impingement, the maximum Nusselt number is widely spread. Location of maximum Nusselt number is studied, which indicates cold spots identification. At a higher angle ratio, the angle is the dominating parameter compared to the Reynolds Number. Whereas at a lower angle ratio, the inclined jet with a higher Reynolds number is giving the cooling point away from leading edge. It is observed that for a particular angle of incident location of maximum Nusselt Number, measured from leading edge of target, is ahead than that of stagnation point in stated conditions.

Cooling Heat Transfer Analysis using Multiple Inline Inclined Air Jet Impingement

“…Various correlations are presented for inclined jets. [44] [45] Cross flow of fluid [46] is studied using 2D jets. A spray cooling effect on cooling performance for electronics applications with different spray angles (0, 20, 40, 50, and 60 Degree) are investigated.…”