Coatings and encapsulants — preservers in the sea

Saroyan, John R.

doi:10.1016/0029-8018(69)90016-x

Cited by 5 publications

(2 citation statements)

References 4 publications

Supporting

Mentioning

Contrasting

Order By: Relevance

“…solar cells, windshields of automobiles, outdoor sports facilities, marine and aerospace structures [1][2][3]. Earlier studies on icephobic coating were primarily focused on salt-glucose compounds [4], cellulose lacquers [5], liquid monolayers such as hydrocarbons, fluorocarbons, waxes, oil, as well as grease and rubber coatings [6][7][8][9][10]. A rapid development of superhydrophobic coatings in recent years [11] offers new opportunities for the design of icephobic coatings.…”

Section: Introductionmentioning

confidence: 99%

Transparent icephobic coatings using bio-based epoxy resin

Zheng

Bellido-Aguilar

et al. 2018

Materials & Design

View full text Add to dashboard Cite

show abstract

Section: Introductionmentioning

confidence: 99%

Transparent icephobic coatings using bio-based epoxy resin

Zheng

Bellido-Aguilar

et al. 2018

Materials & Design

View full text Add to dashboard Cite

show abstract

“…[4] Since then, a lot of research work has been carried out, ranging from liquid & grease filled coatings to modified epoxy or urethane paints. [5,6] Literature study shows that the adhesion strength between ice and solid surfaces depends greatly on the van der Waals forces. [7] In recent years, there has been a growing interest in superhydrophobic coatings consisting of hierarchical micro-nano structures.…”

Section: Introductionmentioning

confidence: 99%

Design and durability study of environmental-friendly room-temperature processable icephobic coatings

Zhao

et al. 2019

Chemical Engineering Journal

View full text Add to dashboard Cite

Research into the Properties of Materials for Underwater Structures in the North Sea

Kievits¹,

Slebos²

1972

Materials & Corrosion

View full text Add to dashboard Cite

Constructing under water has accelerated research into corrosion protection and antifouling properties of materials used below the seawater level. A special working party was founded in the Netherlands to study — theoretically and practically — the corrosion and fouling properties of materials and coatings. A special test rack was immersed at a depth of 50 m in the North Sea in 1969. Experience gained from these experiments gave rise to a joint investigation by 13 laboratories in the Netherlands; the programme involves ten test racks 50 and 100 m below sea level, in the tidal zone and in marine and land atmospheres. The materials studied were: steel with various paints and coatings; stainless steel, Cu, Al and Ti alloys; welded, brazed, nailed and glued stainless steel, Al and Ti alloys; synthetic fibers. The test methods included crevice corrosion and stress corrosion bending tests, electrochemical measurements and the regular control of the biological conditions. The results show the importance of testing in specific marine areas because the results are not readily applicable to conditions in other geographical regions.

show abstract

Coatings and encapsulants — preservers in the sea

Cited by 5 publications

References 4 publications

Transparent icephobic coatings using bio-based epoxy resin

Transparent icephobic coatings using bio-based epoxy resin

Design and durability study of environmental-friendly room-temperature processable icephobic coatings

Research into the Properties of Materials for Underwater Structures in the North Sea

Contact Info

Product

Resources

About