Coastal and deep deformations of the riverbed in the area of a damless water intake

Abstract

The paper analyzes the dynamics of planned and deep deformations on the section of the Amudarya River in the area of the damless water intake in the main structure of the Karshi Main Canal-KMC. The results of field studies of the state of the canal situation of the Amudarya River at the site of a damless water intake are studied. The course of riverbed processes in the riverbed is studied. Recommendations for improving water intake conditions have been developed. According to the results of the field survey and the study of the head section of the supply canal, the state of the Amudarya riverbed in the water intake zone was assessed. The results of surveys of the hydraulic and pumping modes of sediments of the Amudarya River in the area of the damless water intake are analyzed and summarized. The results of field studies of the canal situation of the Amudarya River in the water intake area in the Amudarya River KMC in the area of the Karshi head water intake are studied. The riverbed situation is not characterized by constant hydraulic characteristics over time for the same water flow rate, i.e. with the same water horizon marks, the flow rates may differ from each other by about half, and with the same flow rates, the horizon marks may vary up to ± 0.6 m. This is explained by the extreme instability and high mobility of the canal, and large deformations of the canal occur in a short time. The hydraulic regime of the river is characterized by a significant redistribution of speeds, depth and width of the flow. The range of their changes is within: Maximum speed >Vmax =2…5 m/s; average speed Vav = 0.5…2.5 m/s; depth H max = 4…14 m, Hav = 1…5 m; width B = 300…2000 m; slope i = 0.00016…0.0003. It is established that the characteristic feature of the river is that at a constant flow can have different average velocities depth and width, for example, when Qw = 1000 m3/s, respectively, v = 0.6…1.7m/s, B = 180…1030m, Hav = 1.1…4.3m.

Increasing efficiency of flow energy damping with lateral water intake

“…When installing the model, the width of the tunnel tray was maintained using templates installed in pairs along its entire length [15][16][17][18][19][20][21][22].…”

Algorithms for use of modeling methods in selection process of hydrotechnical construction project

“…, 𝑘 𝑚 − } is formed from the minimum values of the usefulness of criteria achieved in the set of available project variants. Among these project variants, the optimal project variant and the non-optimal project variant have the following characteristics [19,20]:…”

Justification of parameters of sump in machine channel

“…Karimov. As a result of these studies, methods were developed with the conditions for preventing the accumulation of sediments, erosion of the channel, the choice of structural elements, effectively settling sediments as part of a moving stream, and parameters of morphometric elements of the channel [8][9][10][11][12][13][14][15]. As a result of these studies, recommendations were developed for choosing the most hydraulically optimal sections of channel sections and ensuring their efficient operation under certain hydrological conditions.…”