Clayey Nannofossil Ooze Turbidites and Hemipelagites at Sites 834 and 835 (Lau Basin, Southwest Pacific)

Abstract

The western Lau Basin, between the Central and Eastern Lau Spreading Centers and the Lau Ridge, contains several small, elongate, fault-bounded, partially sediment-filled sub-basins. Sites 834 and 835 were drilled in the oldest part of the Lau Basin in two of these small extensional basins close to the Lau Ridge, formed on late Miocene to early Pliocene oceanic crust. Both sites show a similar sediment sequence that consists of clayey nannofossil oozes and mixed sediments interbedded with epiclastic vitric sands and silts. The vitric sands and silts are largely restricted to the deeper part of the sediment column (early Pliocene-late Pliocene), and the upper part of the sediment column at both sites consists of a distinctive sequence of brown clayey nannofossil ooze, stained by iron and manganese oxyhydroxides (late Pliocene-Holocene). However, the clayey nannofossil ooze sequence at Site 835 is anomalously thick and contains several medium-to very thick beds of matrix-supported, mud-clast conglomerate (interpreted as muddy debris-flow deposits), together with large amounts of redeposited clayey nannofossil ooze and coherent rafted blocks of older hemipelagic material. Redeposited clayey nannofossil oozes can be distinguished from hemipelagic nannofossil oozes using several sedimentological criteria. These include variation in color hue and chroma, presence or absence of bioturbation, presence or absence of scattered foraminifers, grain-size characteristics, variability in calcium carbonate content, presence or absence of pumice clasts, and micropaleontology. Clayey nannofossil ooze turbidites and hemipelagites are also geochemically distinct, with the turbidites being commonly enriched in Mn, Ni, Pb, Zn, Cr, and P. The sediment sequence at Site 835 is dominated by allochthonous sediments, either muddy debris-flow deposits, coherent rafted blocks, or thick clayey nannofossil ooze turbidites. Since 2.9 Ma, only 25% of the 133 m of sediments deposited represents hemipelagic deposition, with an average sedimentation rate of 1.5 cm/k.y.~1. Allochthonous sediments were the main sediment type deposited during the Brunhes geomagnetic Epoch and make up 80% of the thickness of sediment deposited during this period. Short intervals of mainly hemipelagic deposition occurred from 0.4 to 0.9 Ma, 1.0 to 1.4 Ma, and 1.7 to 2.1 Ma. However, allochthonous sediments were again the dominant sediment type deposited between 2.1 and 2.5 Ma, with a large slide complex emplaced around 2.5 Ma. We conclude that the adjacent high ground, surrounding the basin in which Site 835 was drilled, was affected by marked instability throughout the late Pliocene and Pleistocene. In contrast, sedimentation at Site 834 during this period has been dominated by hemipelagic deposition, with redeposited sediments making up slightly less than 17% of the total thickness of sediment deposited since 2.3 Ma. However, there was a marked increase in frequency and magnitude of redeposited sediments at around 0.2 Ma at Site 834, which broadly corresponds to the on...

Rapid coupling between solid earth and ice volume during the Quaternary

“…In addition, Unit I includes interbedded turbiditic layers consisting of relatively coarse foraminiferal sand 46 , 48 . According to the onboard initial core description and our smear slide observations, a tephra layer occurs at 11 m below the seafloor (mbsf), and the volcanic component increases to > 10 vol.% in the core sediments adjacent to the tephra 46 , 48 (Supplementary Fig. S3 c, d).…”

Data report: permeability, compressibility, stress state, and grain size of shallow sediments from Sites C0004, C0006, C0007, and C0008 of the Nankai accretionary complex

“…The systematic investigation of particle size distribution of clastic sediments dates back to benchmark studies by, for example, Udden (1914), Wentworth (1922), Spencer (1963), and Folk (1966). More recently, grain size analysis of large populations of sediment samples obtained with modern and fast instruments has found an important application in the study of sedimentary processes and their environmental significance (Stow and Wetzel, 1990;Weedon and McCave, 1991;Jones et al, 1992;Lucchi and Camerlenghi, 1993;Rothwell et al, 1994;Sutherland and Lee, 1994).…”